Check how much force a part can take before it bends, stretches, or breaks.

Housing is brass.

These gauges come with a calibration certificate traceable to NIST that states they've passed a test for accuracy.

Measure the tension of wire or cable.

The large dial makes these gauges easy to read. They measure tension force as well as weight.

Apply your load directly to the top of these gauges to measure compression force.

Take tension and compression measurements at 0.1% accuracy—the highest accuracy of all our force gauges.

Safely view your tension force measurements on a handheld receiver up to 450 ft. away when moving bulk material with cranes and hoists.

Grip paper, film, and thin plastic.

Good for gripping most shapes and materials.

A chuck-style grip with a round opening gets a secure hold on pins.

Measure the force needed to carry out tasks in your facility, such as pushing carts, pulling pallet trucks, or lifting containers.

Calculate how hard it is to peel tape off a surface, separate the layers within a laminate, or unfasten a hook and loop.

Stress test an electrical connection to make sure it won't come apart.

With a sensor that’s already calibrated and everything you need to relay data, these kits come ready to operate. Use them to measure forces in equipment and send the data directly to a computer or PLC to monitor, document, and trigger actions in machinery.

Also known as junction and summing boxes, these hubs combine the measurements of multiple tension and compression force sensors together.

Use these gauges with changeable sensors and square-drive sockets to display, collect, and download torque readings.

Finger-tighten the three-jaw chuck onto a torque wrench or screwdriver, then twist either the gauge or tool to check the tool’s accuracy.

Monitor torque as you apply it—these testers mount between your torque tool and your fastener.

Measure the force of hand and non-impact electric torque screwdrivers to keep fasteners from failing due to under or overtightening.

A dial shows how torque measurements change as you turn the driver. Use these tools to fasten to a specific torque, determine fastener torque specifications, and identify the torque required to loosen tightened fasteners.

A green light and a beep alert you when you've reached 90% of your set torque, and a steady tone sounds once you've hit your target. Set your torque in cNm, cm-Kg, or in.-lbs. and quickly check the LCD for real-time measurements along the way. A red light warns if you begin to overtighten.

Check the tension of your machine’s flat, timing, or V-belt—no matter its width. These gauges use ultrasonic sound waves to take noncontact readings.