Fittings come in two pieces to wrap around rails, so you can quickly modify existing structures without disassembling. Use clamp-on framing and fittings to form temporary partitions, modular conveyors, and workstations.

Half the weight of steel, this aluminum framing resists corrosion in wet environments.

To provide corrosion resistance in wet environments, this framing is galvanized.

In addition to being lightweight and strong, this plastic framing is nonconductive with good resistance to chemicals and salt water.

Attach sensors, tubes, and other components to T-slotted framing rails and structures.

Make your T-slotted framing workstation more ergonomic. These positioning arms let you move tools and other items within reach, reducing fatigue and streamlining repetitive processes.

Stay organized with hooks, bin boxes, shelves, and tool holders that work with T-slotted framing.

With five times the capacity of standard corner clamps, these secure two workpieces at a 90° angle.

Pull the lever to slide the clamping arm along the bar; release to lock in place.

The clamping arm slides freely along the bar for quick, one handed positioning. Tighten the screw onto a workpiece and the arm locks in place.

For the most demanding jobs, these clamps have almost five times the capacity of standard fast-action bar clamps.

All adjustments can be made from one end, allowing clamping in tight spaces.

Each arm slides freely for quick, one-handed positioning. They lock when the screws are tightened onto a workpiece.

Press the trigger to slide the clamping arm along the bar. Release the trigger and squeeze the pistol‐grip handle to lock the clamp in place.

Also known as J-clamps, these provide additional clearance to reach around obstructions and clamp workpieces in recessed areas.

Clamp much farther in from the edge of the workpiece than with standard bar clamps.

These clamps meet DIN VDE 0680-1 for protection against accidental contact with live electrical circuits.

The long, narrow jaws clamp farther into a workpiece and in tight spots.

Clamp thin materials, or use in tight spaces.

Clamp thin sheet material together without drilling holes. These clamps open with special pliers and spring closed when the pliers are released.

Extend the handle to reach the clamp into tight spaces.

Two clamps connected by a pivoting arm hold workpieces at nearly any angle.

Clamp workpieces from the outside at a 90° angle, leaving the inside free for welding or fabrication.

Switch the magnets on these clamps on and off for easy placement and removal of your workpiece.