Diamond cuts more quickly, lasts longer, and leaves a finer finish than other lapping compounds.

Thinner than paste for easier, even spreading over flat surfaces.

A high silver content allows these surface fillers to conduct electricity and heat. Use them to fill gaps and rebuild missing material on electrical connections or to assemble new components.

For use in processing equipment that carries large particles 1/16" in diameter and larger, these ceramic-filled epoxies rebuild and repair surfaces exposed to abrasion from particles, such as pump housings, chute linings, and hoppers.

Mix these two-part surface fillers together to repair leaks and cracks as well as to rebuild rough spots in metal.

These surface fillers can be used on vertical surfaces without sagging. They repair cracked, worn, and damaged surfaces.

Also known as drywall mud, these joint compounds are ready to use. Apply with drywall tape over seams for a finished appearance.

Fill and conceal small cracks, nail holes, and blemishes. Compounds are ready to use.

Fill cracks up to 10" deep on vertical and overhead surfaces.

Patch concrete floors, stairs, and walls with these compounds.

Also known as thread lubricants, these general purpose antiseize lubricants prevent threaded fasteners and close-fitting parts from locking together due to corrosion, contamination, or heat.

Coat tight-fitting metal parts with these lubricants before sliding them together to make assembly easier. Once assembled, they provide initial lubrication in equipment before oil has a chance to flow.

An alternative to nearly dry machining, apply these coolants to tools before milling and machining to reduce heat with minimal cleanup. They’re often used for shallow drilling, reaming, and tapping, as well as on saw blades.

Use this grease in areas where there is the possibility of contact with food. Also known as dielectric grease, it lubricates and protects electrical systems.

Epoxies are the strongest and most weather- and chemical-resistant structural adhesives. They work especially well on metals.

To allow time to adjust and position parts, these epoxies remain workable for at least 90 minutes.

Even when used under water, these adhesives maintain their strength.

Toughened adhesives are blended with rubber particles for better impact resistance than standard epoxies. They form flexible, resilient bonds.

Urethane adhesives are the most flexible, so they bond dissimilar materials and damp vibration.

Acrylics bond to the widest range of materials, especially plastics, and require the least amount of surface preparation.

Install building materials such as wood and drywall with these general purpose adhesives.

Install vinyl and rubber treads on stairs with this adhesive.

Use these adhesives to bond lumber and plywood.

These adhesives maintain their strength at temperatures up to 250° F.

When concrete is saturated or submerged in water, use these adhesives to form strong bonds.

Often used in high-vibration applications that could cause standard thread sealants to fail, these never fully harden and remain pliable enough to self-heal and stop leaks before they start.

Remaining pliable over time, these high-temperature sealants protect against leaks caused by vibration and pressure—they naturally fill voids before leaks can develop.

Also known as thermal paste, these boron-nitride compounds increase heat transfer between parts while preventing them from sticking. Unlike antiseize compounds, they don't conduct electricity, so you won't risk shorting out sensitive electronics.

This thermally conductive coating keeps electrical components cool by dissipating heat.

This coating is formulated for use in sensitive applications such as manufacturing semiconductors.

Identify high spots, interference points, and improper fit on bearings, gears, and valves.