Easy to remove for cleaning and maintenance, these flowmeter/totalizers connect to sanitary quick-clamp fittings (often called tri-clamp fittings) and measure the flow rate and volume of liquid passing through your system. You'll need a gasket and clamp (not included) to connect these to your line. They count how many times their turbine turns as liquid passes through to measure flow. To avoid clogging the turbine and other damage to the sensor, use them only with clean, low-viscosity liquids. You can reset the batch total, but you can't reset the cumulative total. Mount them directly inline with your piping system. They measure flow correctly no matter the mounting orientation.

For use in hazardous locations, these flowmeter/totalizers are FM-approved. They’re also rated NEMA 4 to protect against weather and washdowns.

These flowmeter/totalizers are calibrated with either water or solvent. You can recalibrate them in the field to other liquids, pipe, and operating conditions.

Flowmeter/totalizers with a calibration certificate traceable to NIST states that the flowmeter/totalizer has passed a test for accuracy.

90° display adapter kits let you rotate the meter’s display 90°, so you can read it easier when mounted vertically.

Use these flowmeter/totalizers to measure both the flow rate and total flow volume of oil, gasoline, diesel fuel, and kerosene. They count how many times their turbine turns as liquid passes through them to measure flow. To avoid clogging the turbine and other damage to the sensor, use them only with clean, low-viscosity liquids. You can reset the batch total, but you can't reset the cumulative total. Mount them directly inline with your piping system. They measure flow correctly no matter the mounting orientation. Rated NEMA 4 and IP65, they seal out dust and protect against washdowns.

These flowmeter/totalizers are calibrated with either water or solvent. You can recalibrate them in the field to other liquids, pipe, and operating conditions.

Flowmeter/totalizers with a calibration certificate traceable to NIST states that the flowmeter/totalizer has passed a test for accuracy.

Output modules allow you to transmit flow data from flowmeter/totalizers to an external device such as a programmable logic controller (PLC), data recorder, logger, and remote display (not included). 4-20 mA output modules have an analog output. As flow increases, the output signal from the transmitter increases. For your receiving device to interpret the signal from the transmitter, you will need to calibrate it for the measurement range and output signal of the transmitter. They only give accurate readings within the rated measurement range. Pulse output modules have a digital output. They transmit flow data using spikes of voltage that match the input voltage of the transmitter. The higher the flow, the more pulses they send.

Remote panel-mounting kits let you mount the meter’s display up to 10 feet away.

90° display adapter kits let you rotate the meter’s display 90°, so you can read it easier when mounted vertically.

Determine the amount of gasoline, diesel fuel, and kerosene that flows through these totalizers. They measure the total amount of flow and can be set to measure in batches, which means they measure up to a certain volume. The total cannot be reset, but the batch measurement can. They use positive displacement, so they measure flow by passing specific volumes of liquid through their chamber. They’re accurate in any mounting orientation. Mount them inline with your pipe system. Their mesh strainer traps debris to help prevent clogging.

These totalizers are calibrated with diesel fuel. You can recalibrate them in the field to other liquids, pipe, and operating conditions.