These wipers seal against the cylinder to prevent contaminants from entering between the outside edge and the housing. They’re often used in vertically mounted cylinders.

Note: Maximum performance values cannot be achieved simultaneously; for example, speed is affected by pressure, temperature, and other operating conditions.

For technical drawings and 3-D models, click on a part number.

With a slippery surface, this trim minimizes friction between parts and is often used on conveyor rails, chutes, and guides. Made of plastic, it's also chemical resistant. All of this trim has a hard rating to withstand high levels of impact. It's also nonmarking.

Very flexible trim can be bent around tight corners.

Adhesive-back trim allows for easy installation. Made of UHMW and PEEK, it has good wear resistance.

For technical drawings and 3-D models, click on a part number.

This trim withstands temperatures up to 500° F, which is generally twice as high as our other slippery trim. Made of PTFE, it has a slippery surface to minimize friction between parts and is often used on conveyor rails, chutes, and guides. It's also chemical resistant. This trim has a hard or medium-hard rating to withstand high levels of impact. The harder the trim, the more impact it withstands. All of the trim is nonmarking.

Very flexible trim can be bent around tight corners.

Adhesive-back trim allows for easy installation. It is not for use outdoors.

For technical drawings and 3-D models, click on a part number.

Add a layer of insulation to prevent electricity and heat from dissipating from wire and cable. This sleeving is often used in motors, transformers, and generators. Made of coated fiberglass, it resists abrasion, acids, alkalies, and chemicals.

Acrylic-coated sleeving is more flexible than vinyl-coated sleeving, so it bends around tight corners. It resists solvents and oil.

Protect cable, hose, and pipe from abrasion and cuts in high temperature environments—this sleeving withstands temperatures over 450° F. It expands to fit over items for easy installation; sleeving then tightens around its contents for a secure fit. The braided construction permits heat and moisture to dissipate.

Fiberglass sleeving withstands continuous exposure to high temperatures better than all our other high-temperature sleeving materials. It resists burning and is often used near ovens and furnaces, or to protect exhaust pipes and tubes in mobile equipment. It also resists acids, alkalies, oil, and solvents. Acrylic-coated fiberglass sleeving is more rigid than uncoated fiberglass sleeving and minimizes fraying when cut. It has good abrasion and chemical resistance.

Install building materials such as wood and drywall with these general purpose adhesives. Use cartridges with a standard caulk gun.