Adjust shaft speed and torque for use in low-speed, high-torque applications.

The input and output shafts are positioned at the same height, so these speed reducers take up less than half the vertical space as our standard right-angle speed reducers.

With a sanitary design for food-processing environments, these speed reducers mount to the face of your motor—no coupler required—to slow shafts and increase torque while transmitting motion at a 90° angle.

Mount right-angle speed reducers to machinery or other surfaces where access from the bottom is not possible.

Shaft diameters range from 5 to 35 mm.

Mount these gears to a NEMA motor. Spur gears minimize torque loss between your motor and drive shaft, making these speed reducers more efficient than our other speed reducers.

Made from carbon steel with spiral teeth, these gears handle heavier loads at higher speeds than bevel gears with straight teeth because their teeth stay in contact longer.

Also known as spiral miter gears, these gears have curved teeth that gradually engage and stay in contact longer than straight teeth so they handle heavier loads at higher speeds. Speed ratio is 1:1.

The current industry standard, these 20° pressure angle gears have thicker, stronger teeth than 14½° pressure angle gears. They're also known as spur gears.

A former industry standard, 14½° pressure angle gears are often found on older machinery.

Connect two shafts at a right angle without changing shaft speed or torque.

A former industry standard, 14½° pressure angle gears are often found on older machinery.

A light duty alternative to metal, plastic gears have good corrosion and chemical resistance.

Broad, strong Acme threads make these screw jacks better than ball screw jacks for heavy loads, intermittent positioning applications, and where vibration is present.

Use these general purpose shafts with bearings, sprockets, and gears to transmit rotary motion.

Connect these internally threaded shafts directly to threaded components, or use a fastener to secure. They have a flat surface area that allows set screws to dig into the shaft for securely mounting gears, sprockets, and bearings.

These shafts have keyways only on the ends, leaving a plain shaft in the center. Use the keyways with machine keys to transmit torque to gears, sprockets, and other keyed components. Use the middle of the shaft with bearings and other round-bore components.

Attach threaded accessories, such as mixer propellers and fan blades, to the end of these shafts.

Mount the flange to a machine or wall to support idler sprockets and pulleys in tensioning applications. They include washers and a nut to position your component and hold it in place.

A shoulder near the end of the shaft provides a stop for gears, sprockets, and bearings.

Connect these internally threaded shafts directly to threaded components, or use a fastener to secure.

Keep a material certificate on hand for compliance and quality assurance needs. Certificates include a traceable lot number and material test report. These hollow shafts reduce system weight and allow you to run various media such as electrical wiring, compressed air tubing, coolants, or lubricants through the center.

With 2" of each end softened, it's easier to machine a custom end for mounting. The rest of the shaft is case-hardened, which increases hardness and wear resistance on the surface of the shaft while allowing the center to remain soft for absorbing stresses caused by shifting loads.

Mount these externally threaded shafts into tapped holes rather than using a shaft support, or attach a hex nut, shaft collar, or other threaded accessory.

Lighter than solid shafts, hollow shafts reduce your total system weight and allow you to run various media such as electrical wiring, compressed air tubing, coolants, or lubricants through the center.

A shoulder near the end of the shaft allows for easy positioning of housings, shaft supports, and collars.