McMaster-Carr logo
    Clear All
    Component
    Component
    Gear
    System of Measurement
    System of Measurement
    Inch
    Metric
    For Shaft Diameter
    For Shaft Diameter
    default
    1/2"
    5/8"
    3/4"
    4 mm
    5 mm
    6 mm
    8 mm
    10mm
    Speed Ratio
    Speed Ratio
    10:1
    15:1
    20:1
    30:1
    40:1
    50:1
    60:1
    Module
    Module
    click to learn more about
    Material
    Material
    Show
    Bronze
    Number of Teeth
    Number of Teeth
    20
    30
    40
    50
    60
    Pressure Angle
    Pressure Angle
    14 1/2°
    20°
    For Number of Thread Starts
    For Number of Thread Starts
    1
    2
    Gear Type
    Gear Type
    Worm
    Face Width
    Face Width
    default
    1/2"
    5/8"
    5 mm
    9 mm
    10 mm
    12 mm
    Overall Width
    Overall Width
    default
    1"
    1.12"
    1.245"
    1 3/8"
    12 mm
    18 mm
    20 mm
    22 mm
    Hub Material
    Hub Material
    Bronze
    Hub Width
    Hub Width
    default
    0.5"
    0.62"
    0.75"
    7 mm
    9 mm
    10 mm
    Bore Type
    Bore Type
    Round
    Teeth Fabrication
    Teeth Fabrication
    Not Ground
    Teeth Heat Treatment
    Teeth Heat Treatment
    Not Hardened
    RoHS (Restriction of Hazardous Substances)
    RoHS (Restriction of
    Hazardous Substances)
    RoHS Compliant
    RoHS Compliant with
    Exemptions
    DFARS (Defense Acquisition Regulations Supplement)
    DFARS (Defense Acquisition
    Regulations Supplement)
    click to learn more about
    REACH (Registration, Evaluation, Authorization and Restriction of Chemicals)
    REACH (Registration,
    Evaluation, Authorization
    and Restriction of Chemicals)
    REACH Compliant
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)
    25 Products