Accommodate joint movement with these adhesives that remain pliable when cured.

For easy positioning, these adhesives begin to harden only when exposed to light.

Epoxies are the strongest and most weather- and chemical-resistant structural adhesives. They work especially well on metals.

To allow time to adjust and position parts, these epoxies remain workable for at least 90 minutes.

Acrylics bond to the widest range of materials, especially plastics, and require the least amount of surface preparation.

Apply this glue like tape for a no-mess alternative to liquid adhesives, hot melts, and staples. Also known as adhesive transfer tape.

Spray a thin, uniform coat of adhesive on one or both surfaces, air dry, and then bring together to form strong bonds.

Resistant to mold and mildew, these sealants are well suited to high-humidity environments.

Also known as thumb-grade caulk, this forms a non-hardening, moisture-resistant seal that remains pliable.

These sealants are non-sagging, so they won't drip from vertical and overhead surfaces.

Repair equipment and vehicle windows with these sealants that are rated to withstand impact within three hours of application.

Thinner than non-sag sealants, these flow easily into cracks and have a smooth finish.

Thinner than non-sagging sealants, these flow easily into cracks and have a smooth finish.

Clear enough to read through, this UV-resistant potting compound allows optimal light transmission for use with LEDs, solar cells, and fiber optics.

The strongest of the potting compounds, epoxies are rigid and wear resistant. They have excellent chemical and moisture resistance, withstand a wide range of temperatures, and provide excellent electrical insulation.

Thinner than potting compounds, these rigid and wear-resistant coatings flow easily into small spaces between electrical components. Use them to secure and insulate hardware on printed circuit boards.

These coatings require an ultraviolet curing lamp to reach full strength.

Clear enough to read through, this coating allows optimal light transmission for use with LEDs, solar cells, and fiber optics.