Filter by
Color
Touch Dry Time
Container Type
Formulation
Consistency
Clarity
DFARS Specialty Metals
Export Control Classification Number (ECCN)
Hardness Rating
REACH
RoHS
Hardness
Light Intensity Requirements to Reach Full Strength
Mixing Required
Tensile Strength
Dielectric Strength
Overall Dry Time
Thermal Conductivity
Maximum Temperature
Minimum Temperature
Manufacturer Model Number
Container Size
Manufacturer
About Paint and Protective Coatings
More
Heavy Duty Light-Activated Coatings for Electronics
Thinner than potting compounds, these coatings flow easily into small spaces between electrical components. They require an ultraviolet curing lamp to reach full strength. Use them to secure and insulate hardware on printed circuit boards.
Syringe coatings require a gun (sold separately) to dispense.
Dry Time | |||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| Mfr. | Mfr. Model No. | Container Size, fl. oz. | Consistency | Touch, sec. | Overall | Hardness Rating | Dielectric Strength, V/mil | Temp. Range, °F | Light Intensity Requirements to Reach Full Strength | For Use On | Color | Each | |
Syringe Coatings | |||||||||||||
| Loctite® | 3751 | 4/5 | Thin Liquid | 10 | 2 min. | Extra Hard | 730 | -65° to 270° | 10 seconds @ 100 mW/cm 2 | Aluminum, Brass, Bronze, Copper, Steel, Stainless Steel, Silver, Titanium, Plastic, Composites, Fiberglass | Yellow | 00000000 | 000000 |
| Dispensing Guns for Syringes | 0000000 | Each | 000000 |