Dispense from grease guns into grease fittings and bare lubrication points.

These flexible nozzles have threads on both ends for connecting a grease gun to a dispensing tip.

Slide the metal sleeve up to the tip for rigidity. Slide it back down to expose the flexible nozzle.

Penetrate gaskets, sealed bearings, and joints to deliver grease to precise locations.

Dispense from grease guns into grease fittings and bare lubrication points.

Lubricate standard grease fittings in hard-to-reach areas. Extensions have a quick-disconnect fitting that snaps into your dispensing tip for standard grease fittings.

Mount holders in convenient locations to keep grease guns within reach.

Deliver small amounts of grease with only a light push against the lubrication point.

These guns deliver twice as much grease per stroke than standard lever-grip guns.

Switch between high-pressure and low-pressure settings. Use high pressure to dispense thicker grease or to force grease through clogged fittings. Use low pressure for high-volume dispensing.

Ensure that only food-grade grease is used in controlled areas—this gun only works with compatible food-grade grease cartridges.

Dispense small amounts of grease with this compact gun.

Be sure you’re using the right grease—this gun has a clear barrel for identification at a glance.

Use compressed air to dispense grease.

Dispense small amounts of grease with one of these compact guns.

Replace the dispensing tip on your filler pump.

Useful in remote areas without access to air or electrical power.

Lubricate single- and double-strand roller chain.

Don’t wait for grease to travel through a new service line—install this grease-filled tubing between the pump and a lubrication point to begin lubricating immediately.

Tighten the cover to dispense grease.

Dispense grease using compressed air.

Switch between high-pressure and low-pressure settings. Use high pressure to dispense thicker grease or to force grease through clogged fittings. Use low pressure for high-volume dispensing.

Move grease-dispensing guns in any direction without kinking the outlet hose.

Increase the pressure of your grease system when necessary to dispense thick grease and force grease through clogged fittings.

Use these brushes to lubricate chain, gears, and conveyors. Connect to an oil dispenser, then turn the dial to adjust flow.

Connect these brushes to oil reservoirs and flow adjustment valves to lubricate chain, gears, and conveyors.

Keep thin grease from leaking out—the check valve on these fittings has a Buna-N seat that creates a tighter seal than check valves on other grease fittings.

Prevent damage to bearing seals caused by over-lubrication—these fittings automatically stop grease flow when pressure is within the shut-off range.

Often used on earth movers, mining equipment, and other heavy machinery, these fittings have a T-shaped top that holds the dispensing tip in place so it won't pop off when adding grease.

Drive these fittings into unthreaded holes. They're also known as hydraulic grease fittings.

Use these fittings in tight spaces where protruding fittings won't work. Drive them into unthreaded holes.

When the size or thread type of a fitting doesn't match an existing opening, use these adapters to make the connection.

Access difficult-to-reach lubrication points from up to 10 ft. away.

Fill these tools with light oil, then tap with a hammer to open clogged fittings.

Tap these tools once or twice with a hammer to install fittings.