Use this general purpose grease to lubricate most machinery.

Nano-sized additives penetrate small surface imperfections, reducing wear and heat to extend the life of both the lubricant and equipment. It's formulated to adhere to metal parts and to stay in place in wet environments.

Brush on most metal surfaces to provide a layer of protection against corrosion.

For use on metal parts to prevent corrosion and as an antiseize lubricant. Gauges are often coated in a thin layer of lanolin to move smoothly and maintain their precision.

Made with moisture-resistant thickeners, this grease stays in place in wet environments. It is NSF registered H1 and FDA compliant for incidental food contact.

This grease stands up to the high speeds typically found in automated applications.

For use in high-pressure applications, this grease prevents wear and corrosion at loads up to 50,000 psi.

Highly pure, this grease won't contaminate sensitive environments, so it can be used in clean rooms.

Use at pressures up to 50,000 psi.

Increase the pressure mineral oil can withstand in low-speed, high-pressure applications, such as gears, plain bearings, and ways.

This thin lubricant penetrates into tight spaces, and nano-sized additives fill small surface imperfections, reducing wear and heat and extending the life of both the lubricant and equipment.

For use in food-processing and preparation areas, these thin, multipurpose lubricants are NSF registered H1 for incidental food contact.

Protect food-processing and preparation equipment while limiting environmental impact. These multipurpose lubricants are NSF registered H1 for incidental food contact and are rated to quickly break down in water.

Spray these lubricants onto wire rope and cable used in vertical or fast-moving applications. They dispense as a thick gel, completely covering wire strands without dripping or running off. Use them to cut through dirt, grease, and rust, and to protect wire rope and cable.

Protect electrical components—these lubricants insulate and block moisture, preventing electrical malfunctions. They cut through dirt, grease, and rust to clean connections and relays, leaving behind a thin film for long-lasting protection.

Use these NSF registered H1 lubricants in food-processing and preparation areas with a risk of incidental food contact. They form a nonstick film that won't attract contaminants, such as flour.

Also known as antifriction coatings, these slippery coatings cure to provide permanent lubrication. They're made with moly for high-load applications, such as hinges, gears, and rods. They fill in surface imperfections for a smooth, dry finish that won’t attract dust.

Made of graphite, these powders and flakes lubricate under heavy loads and high temperatures. They resist most chemicals and conduct heat and electricity. Use them dry or mix with oil and grease.