Designed to stand up to heavy use, these wheels remove more material than our general purpose grinding wheels.

Typically used with cylindrical, surface, and ID grinders, these wheels are specially designed to grind the inside diameter of workpieces.

Made with boron nitride, second in hardness to diamond, these wheels are highly wear resistant and easily cut difficult-to-grind steel parts.

A good value for everyday use, these wheels offer an economical balance between heavy material removal and long life. They are also known as Type 27 wheels, raised-hub wheels, and grinding discs.

A blend of ceramic alumina and zirconia alumina removes material at a 50% faster rate than our Long-Life Grinding Wheels. Wheels are also known as Type 27 wheels, raised-hub wheels, and grinding discs.

A large grinding surface, combined with a thick layer of rough abrasive removes more material than other wheels. They are also known as Type 11 wheels, flared-cup wheels, snagging wheels, and cup stones.

A blend of cotton laminate and aluminum oxide creates a smoother surface than other grinding wheels with similar grits. Wheels are also known as Type 27 wheels and raised-hub wheels.

Silicon carbide cuts through concrete and stone without generating much heat. Wheels are also known as Type 27 wheels, raised-hub wheels, and grinding discs.

Quickly remove vinyl, decals, tape, and double-sided molding striping and trim without damaging the surface below.

Overlapping abrasive flaps bonded to a backing plate provide consistent material removal and even finishes.

These discs have a harder abrasive than standard flap sanding discs.

These discs have a harder abrasive than standard quick-change discs.

The abrasive-embedded nylon mesh construction gives you more control over sanding pressure.

The nylon mesh on these discs is embedded with precision-shaped ceramic alumina, which cuts through hard metals like stainless steel faster than other forms of ceramic alumina because of its sharp, outwardly pointed grit.

A special fastener on the back of these discs allows you to easily swap one disc for another.

The abrasive-embedded mesh construction gives you more control over sanding pressure, creating finer and more consistent finishes.

When you need to achieve a more consistent finish, choose nylon mesh sanding discs over paper- or cloth-backed discs.

The cushioned construction gives you more control over sanding pressure, creating finer and more consistent finishes.

The nylon mesh on these discs is embedded with precision-shaped ceramic alumina, which cuts through hard metals like stainless steel faster than other forms of ceramic alumina because of its sharp, outwardly pointed grit.

The cushioned construction gives you more control over sanding pressure, creating finer and more consistent finishes.

Prepare material surfaces for finishing processes such as coating, painting, and soldering—these discs contain an extra coarse ceramic alumina abrasive for heavy cleaning and stripping of stainless steel, nickel, and other hard metals.

Also known as Type 27, raised-hub, and depressed-center cutoff wheels, these wheels outperform Type 1 wheels when making flush cuts in metal.

Also known as Type 27, raised-hub, and depressed-center cutoff wheels, these wheels outperform Type 1 wheels when making flush cuts.

Run these high-density aluminum oxide wheels at higher speeds than standard cutoff wheels to make quick cuts in aluminum, iron, stainless steel, and steel.

These high-density ceramic or ceramic oxide wheels have two layers of fiberglass mesh reinforcement and last up to twice as long as long-life cutoff wheels when cutting iron, stainless steel, and steel.

With less than 0.1% iron, chloride, and sulfur contaminants, these wheels prevent corrosion and discoloration on stainless steel.

The combination of ceramic alumina and zirconia alumina in these wheels lasts up to ten times longer than aluminum oxide when cutting hard metal such as Inconel, Hastelloy, and tool steel.