Protect against accidental contact with live electrical circuits. These insulated retrievers are tested to 1,000 volts to meet IEC 60900 and ASTM F1505. The shaft bends and stays in position to reach objects in awkward spaces.

Avoid the potential for an arc flash or short circuit that can occur when using conventional insulated tools with metal components. Completely metal-free, these pliers are plastic with ceramic cutting blades. They are tested to 1,000 volts to meet IEC 60900 and ASTM F1505. Use to pull, bend, and cut wire.

Choose plastic tweezers for a soft, nonmarring grip. These tools are corrosion resistant and nonmagnetic.

Remove chips and other delicate components from circuit boards.

Avoid nicking or scratching sensitive components. Also known as spudgers, these picks are good for adjusting small wires or separating press-fit plastic components.

Racks have multiple holders to organize items.

Adhesive strips let you remove and reuse these holders without damaging the wall.

Built with snap-in tabs and a spring extension, these cord grips install into panel holes more quickly than standard grips and better prevent damage from sharp bends.

These grips install into enclosure holes quickly to stabilize and relieve strain on cords.

An insert clamps the cable in place to provide more strain relief than other snap-in cord grips for building cable.

Wrap the split gland of these grips around ethernet cables with an RJ45 connector or other already installed cables for a water-resistant seal with your enclosure.

Able to withstand temperatures up to 300° F, these grips are also corrosion- and chemical-resistant.

A rubber bushing with an oval slot resists water and provides entry for building cable, which is also known as Romex type NM-B or type UF-B cable.

Secure installed cords in wet environments with temperatures up to 300° F while guarding them against sharp bends. These PVDF grips stand up to corrosion, chemicals, and heat, making them good for use in food and beverage plants as well as clean rooms that require high-temperature sanitizing.

Snap these cord grips into place to secure cable in wet environments.

Tighten the screw-down clamp for superior pull-out resistance.

These grips are made of nylon, which resists most chemicals. The nylon mesh extension provides a secure hold when the cable is pulled or in motion.

Also known as cable-entry seals, the cable-entry side has heat-shrinkable polyolefin with an adhesive lining.

The cable-entry side has heat-shrinkable polyolefin with an adhesive lining. These are also known as cable-entry seals.

Peel away layers of rubber inserts to fit around cord grips, even when you don't know the exact diameter.

The face of these grips is flush with the cable-entry point for a seamless appearance.

Protect cords routed through holes in enclosures and panels.

Shaped to fit the contours of your hand, these ergonomic grips provide a comfortable, firm grasp.

These grips are grooved to conform to your fingers for a comfortable, secure grasp. Slide them onto a round tool handle and use the eye to hang them. All are made of vinyl for strength and durability.

Grips are grooved to conform to your fingers for a comfortable, secure grasp.

Place these plastic pellets in hot water until they soften and become pliable. Then mold the material directly to your handle to create a custom grip.

Add or replace worn grips on a variety of irregularly shaped handles and objects. Cut these grips to your desired length with scissors and slide them on your object. Use a heat gun to shrink them tightly in place.

Magnets hold sockets securely in place.