Custom fit these grommets to your wire, cable, or cord by cutting a hole in the thin rubber layer. They also block out debris and reduce vibration, so they’re good for use around electronics and other sensitive components.

Press these slim, flexible grommets into a hole when space is too tight for a sandwich mount. They block vibration around sensors and other parts you count on for precise movements, strong signals, and accurate readings. The rubber stem and two flanges line the inside and both faces of a hole so no vibration can flow between the fasteners and mounting surface.

Expanding wings lock these grommets into the hole so they stay put when installed vertically and in vibrating equipment. They fit a range of panel thicknesses, so grommets from one pack will fit holes of different depths.

The ribs flex to absorb slow, rumbling vibrations better than smooth rubber grommets. Press into a hole to protect fine-tuned equipment from the vibration of nearby traffic and heavy machinery.

The ribs flex to absorb slow, rumbling vibrations better than smooth rubber bushings. Install these bushings around shafts, large fans, and other slow-rotating components to extend part life and minimize downtime. Pair a ribbed vibration-damping washer with a bushing to absorb more vibration.

These punches set grommets that have an extended-neck washer, a standard washer, or a tooth-lock washer. Strike the punch with a wooden or rawhide mallet. Punch and die are stamped with the corresponding grommet trade size.

Punch a hole in your material to prepare for the installation of fabric grommets. Strike these tools with a wooden or rawhide mallet.