Kits include grommets, a cutting punch, a cutting block, an installation punch, and a die set. Use them to create a way to run rope and cable through tarps, covers, and curtains.

The extended neck on the washer of these grommets adds reinforcement so you can use them in thicker material such as woven fabrics. Press them into a hole you've already cut. They strengthen and prevent holes from fraying in tarps, covers, and curtains. They also provide a way to run rope and cable through your material.

Keep cords from coming loose and seal water out of enclosures in extremely cold labs and storage areas. Thanks to their plastic bushing and rubber O-ring, these grips withstand temperatures as low as -75° F.

Secure cable installed through enclosures in wet environments while venting air to protect electronics from condensation.

These grips are nickel-plated brass for good corrosion resistance.

Modify these cord grips to get the right fit for your cord even when you don't know the exact diameter.

Pair these male snap halves with female snap halves to make a complete snap.

Kits include a hand punch tool with die and six complete snaps.

Once installed, these fasteners provide a male snap half on both sides of your fabric. Create a complete snap by joining each male side with a female snap half for a finished look on assembled layers of fabric.

Kits include a hand punch tool with die and six complete snaps with tapping screw studs.

The threaded stud installs in threaded holes.

Fasten these male snap halves to a solid surface when you only have access to one side. A blind rivet tool is required for installation.

Use screws to secure these bases in a solid surface.