The smooth, flat design provides more surface area contact than wire or braid.

Connect an electrical system to a ground. These copper-plated steel rods provide high levels of conductivity and good corrosion resistance. They are tapered at one end for easy driving. All meet UL 467 for direct burial.

Threaded rods provide the best connection when joining two rods with a connector.

Connectors are high-strength, corrosion-resistant, and highly conductive. They make permanent connections between two rods. One end is chamfered and the other is tapered for easy driving.

Driving heads protect rod ends from "mushrooming" when driven into the ground.

For technical drawings and 3-D models, click on a part number.

These gaskets absorb electromagnetic interference (EMI) and radio frequency interference (RFI) to prevent inaccurate signals, flickering displays, and other electrical problems. They compress to fill gaps and complete a grounding path around doors and access panels.

Sheets work well between two flat surfaces.

Half-round gaskets work well in grooves. Use a gasket slightly thicker than the depth of the groove; it will compress to fill the gap.

P-shaped gaskets fit around doors and corners. Attach them with the nonconductive adhesive or add bolts or screws through the flange for extra security.

Urethane foam gaskets block EMI and RFI in most applications. Adhesive-back gaskets are wrapped with conductive aluminum foil and stick on with a conductive adhesive. They meet UL 94 V-0, so they self-extinguish within 10 seconds if they catch fire and won’t spread the fire by dripping. Plain-back gaskets are made with conductive silver wire. They meet UL 94 HF-1, which means they stop burning within two seconds if they catch on fire and won’t spread the fire by dripping.

Polyurethane foam gaskets are covered with a conductive nickel/copper braided fabric. A nonconductive adhesive holds them in place. To protect sensitive equipment, they block at least twice as much interference as urethane foam gaskets. They meet UL 94 V-0, so they self-extinguish within 10 seconds if they catch fire and won’t spread the fire by dripping. Cut these gaskets to length with scissors.

Silicone rubber sheets are embedded with conductive nickel wire. They block the most interference of our shielding gaskets and also seal out moisture. One side is smooth; the other is rough to help adhesives stick. They meet AMS, ASTM, and military standards for materials.

Beryllium copper gaskets withstand repeated compression and decompression over time, so they’re often used with doors that regularly open and close. They’re also known as fingerstock gaskets. Adhesive-back gaskets stick to flat surfaces. Install clip-on gaskets onto surfaces such as circuit board edges or enclosure door frames.