Use brackets and connectors to create vertical and horizontal support arms.

Also known as cross blocks, connectors join rods at different angles.

Combine these general purpose shafts with a linear bearing and shaft support to create a basic linear motion system.

Position shafts an inch or two off the ground to maintain bearing and part clearance. Support rails provide stability over the entire length of shaft, allowing virtually unlimited travel lengths and eliminating bending under moderate to heavy loads.

These two-piece supports allow access to the shaft without needing to slide out the shaft or uninstall the support. Use them to brace the end of a linear shaft when working with light to medium loads where shaft alignment is not critical. Tighten the included clamping screws to secure.

Create a support that fits the exact dimensions of your shaft. Good for use with square- and hex-profile shafts, these aluminum supports also work with round shafts of any diameter up to 1". Use them for light-to-medium-load linear motion applications where shaft alignment is not critical.

Check external NPT thread size and taper.

Use these highly accurate straightedges as a guide to scribe and cut straight lines and to check surface straightness.

Twist these lock rings onto bushings to secure them in drilled holes.

Build these components into fixture plates, machine subplates, and tombstones for quick changes. The system clamps and locates at the same time for accurate positioning with repeatability of ±0.0005".

Built to withstand corrosive marine environments, track is anodized aluminum and hangers are 316 stainless steel.

These sets include everything you need to hang two doors that slide past each other.

Install these drawer slides in small-parts cabinets.

With fewer moving parts than other lock-open drawer slides, these collect less debris for a longer service life.

Press these grommets into a hole you've already cut. They strengthen and prevent holes from fraying in tarps, covers, and curtains. They also provide a way to run rope and cable through your material.

Also known as sheaves, use these pulleys to assist with horizontal pulling or to guide a rope.

Hang these pulleys from hooks, screws, and bolts to assist with horizontal pulling or to guide a rope.

Attach conduit to a knockout in an outlet box or enclosure.

Also known as conduit bodies, these ports provide access to wire and cable inside thick-wall (rigid) metal conduit for pulling, splicing, and maintenance. They are also used to change the direction of a run.

Create a connection point to route overhead service wire and cable from utility poles to electrical meters, bringing power to buildings.

Attach conduit to a knockout in an outlet box or enclosure.

This nonmagnetic aluminum conduit withstands damp and corrosive environments.

Attach conduit to a knockout in an outlet box or enclosure.

Secure threaded metal conduit fittings to a knockout in an outlet box or enclosure.

With the widest channels of any of our cable ramps, these ramps can span large cable, hose, and pipe.

This sleeving reflects heat away from contents and withstands temperatures up to 900°F. The corrugated construction gives it impact and abrasion resistance similar to conduit, but with more flexibility.

The smooth ring handle on these pins won't catch on parts. A spring-loaded, nonlocking retaining ball pops out when the pin is pushed through a hole, and retracts when the pin is pulled out.

For a more secure connection than rail- and adhesive-mount clamps, weld the bottom plate of these clamps onto your rails. They fit tightly around pressurized lines in hydraulic systems to lessen vibration.

A molded cushion reduces vibration and wear from clamp edges, plus it provides a tighter fit around material than standard vibration-damping loop clamps.

Mount these general purpose U-bolts into an existing bracket, or combine with a mounting plate for a secure hold at the mounting surface.