These switches use DC input voltage and produce PNP or NPN signal output. They're often used with programmable logic controllers (PLCs).

With a smaller diameter and shorter length than standard sized switches, these fit in the most space-constrained areas.

Sense objects from farther away than with other DC proximity switches that have the same diameter.

These inductive proximity switches sense metallic objects each time they pass through the slot, even when they’re obscured by water, oil, dirt, or a surface finish. Use them to measure the speed of rotating equipment and to count or detect moving objects, such as sheet metal being fed into a stamping process.

For use in volatile areas, these intrinsically safe switches detect objects when they pass through the slot. They use a NAMUR signal to operate at a low current and voltage, so they won’t ignite or create sparks. ATEX and IECEx certified, they protect against explosion.

Twist the sensor to detect metallic objects where explosive dust or gas may be present—the sensor rotates for front, side, top, or bottom sensing. These switches are UL and C-UL listed as well as ATEX and IECEx certified for hazardous locations.

Turn the face on these switches to sense metallic objects from the front, sides, top, or bottom.

Mount these intrinsically safe switches to flat surfaces in volatile areas. Their low-current, low-voltage NAMUR signal means they won’t ignite or create sparks while in use. ATEX and IECEx certified, they meet international standards to protect against explosion where combustible dust and flammable gases are present.

Check the position of your torch or workpiece for accuracy during robotic welding.

Actuate your switch with precision—these proximity switches have an easy-to-read screen for precise distance inputs, measurements, and troubleshooting.

Most often found in older devices, these switches require AC input voltage.

Mount these flat inductive switches to a base or rail to remotely detect metallic objects in wet and dirty environments.

Send signals in response to changing magnetic fields to trigger processes or monitor position, speed, and current.

These switches sense when a valve is open or closed, supporting flow and temperature control within your system and offering reliable feedback.