The scratch-resistant coating on these face shields extends the lens life.

The lens on these face shields is coated for an added level of protection against most chemicals.

The coating on these face shields reflects radiant heat to keep your face cooler.

Attach these to the brim of cap-style hard hats to provide full-face protection.

Extend your peripheral vision with an extra-wide lens. To fully protect your eyes against flying dust and debris, safety goggles provide a complete seal. The adjustable headband prevents them from shifting or falling off.

Store safety glasses close at hand. Cases have a pocket clip, belt loop, or snap hook for convenient attachment.

These hoods meet NFPA 70E standards for protection against electrical arc flashes for personal protection equipment (PPE) category 4.

Designed for continuous-use welding, these goggles protect your eyes from harmful infrared light.

Providing greater safety while welding than face shields, these helmets have an outer filter lens cover for protection from scratches and weld spatter.

Soft and absorbent, these headbands keep perspiration out of your eyes.

Keep your hair out of the way.

Keep sunlight off of your skin and sweat out of your eyes

These hats are made of an aramid blend that meets NFPA 70E for protection against electrical arc flashes while keeping you warm.

Made of soft cotton fleece, these earmuffs wrap behind the head to shield ears from the cold and wind.

These face masks are made of an aramid blend that meets NFPA 70E for protection against electrical arc flashes while keeping your head and neck warm.

Keep your head and neck warm.

Wear these fluorescent hats to stand out in low-visibility areas and high-risk jobsites, such as vehicle roadways and construction sites.

Keep your hair out of the way to prevent stray hairs from contaminating food.

Swap these covers out after every use to keep shared earmuffs, headsets, and headphones germ-free without sterilizing them.

These face masks are double-layered to protect your head from radiant heat, flames, and welding sparks.

Wear these breathable hoods to keep cool while protecting against dirt and grime.

These beanies are designed for a snug fit and provide good breathability.

Good for use around abrasive blasters and paint sprayers, these respirators are made of high-density materials that protect against rough airborne particles.

These respirators have a chemical-resistant Tychem 2000 hood that protects against light liquid splashes.

Earmuffs should be worn with the specified fit to offer proper protection and noise reduction.

Stay connected while protecting your ears in noisy locations. Listen to music or make phone calls using a Bluetooth-enabled smartphone up to 30 feet away.

Protect your head from minor bumps and scrapes. Attach a lens to protect against dust and spray.

Hold your hard hat securely on your head with these chin straps.

Keep hard hats close at hand but out of the way.

Convert a baseball cap into a bump cap to protect your head from minor bumps and scrapes.

For protection from more than just falling objects, these hard hats are rated ANSI/ISEA Z89.1, Type II to deflect both top and off-center blows to the head.

Keep your hands free by wearing a flashlight on your head.

Rated IP07, these headlamps withstand temporary submersion in a maximum of one meter of water for up to 30 minutes.

Clip these little flashlights to any surface up to 1/2” thick and keep your hands free for work. They're rated for use in environments where hazardous material is present.