Also known as heat blankets, these heaters completely surround containers for fast heating and increased heat retention in unheated and drafty areas.

Extend the shelf life of your diesel exhaust fluid (DEF) while storing it in cold places.

Heaters are fiberglass-reinforced silicone rubber.

Strap these heaters around cylinders to keep gas flowing when the temperature drops. Also known as heat blankets, they heat cylinders from the outside, safely warming liquefied gas enough so that it can vaporize.

To prevent hot spots that can damage heat-sensitive materials such as adhesives, sealants, and food, these heaters warm the air around containers without touching them.

An adjustable thermostat senses the container’s surface temperature to automatically control heat output.

For more durability than other adhesive-mount heaters, a thick layer of fiberglass-reinforced silicone rubber encases the heating element.

FM approved, these heat sheets are safe for use in areas with infrequent exposure, such as from a spill or a ventilation system failure, to flammable gases, liquids, and dust.

The thermostat automatically turns these heaters on when the temperature drops below 38° F and turns them off when the temperature reaches 45° F.

With a cable that supplies the same wattage along the entire length, these heaters remain consistent regardless of the surrounding temperature. All require a temperature switch or controller to regulate heat output.

When the ambient temperature changes, these heaters automatically adjust the heat output along the length of their cable. Also known as self-regulating heat cable, they don’t require a separate temperature switch or controller.

Keep liquid in your pipes from freezing, maintain a specific viscosity, and prevent condensation in cold areas.

For demanding applications such as hot-melt transfer pipes, these heaters have a maximum heat output of 1400° F.

Keep your battery running at full power even when the temperature drops—these heaters warm batteries quickly without overheating them.

Often used with extrusion, injection, and blow-molding machinery, these heaters clamp around nozzles to keep material warm for consistent discharge.