Heater Cable | McMaster-Carr

Filter by

Voltage

Length

American Wire Gauge (AWG)

Number of Wires

Maximum Temperature

Maximum Heat Output

Current @ Temperature

Heat Cable Type

Outer Jacket Material

Width

Watt Density

Maximum Environment Temperature

Outer Jacket Color

Flexibility

Surface Material

Wattage

Certification

UL Recognized Component

Use For

Panel and Equipment (Hook-Up)

RoHS

Compliant

Not Compliant

Export Control Classification Number (ECCN)

EAR99

DFARS Specialty Metals

For Use Outdoors

REACH

Cable AWG

Temperature Control Type

Nonadjustable Thermostat

Time-Cycle Controller

Without Temperature Control

Forward

How can we improve?

238 Products

About Heaters for Pipes and Tubes

Self-Regulating Heat Cable—Adjusts its heat output in response to surface as well as surrounding temperatures.

Constant-Wattage Heat Cable—Always puts out the designated amount of watts/ft., regardless of the surrounding temperature.

Constant-Wattage Heaters with
Temperature Control for Pipes and Tubes

The thermostat automatically turns these heaters on when the temperature drops below 38° F and turns them off when the temperature reaches 45° F.

Constant-Wattage Heaters with Adjustable
Temperature Control for Pipes and Tubes

Turn the dial to control the percentage of time that these heaters cycle on, from 5% to 100%. Commonly used to thaw pipes, prevent valves from freezing, and heat beakers and flasks in labs, they're good for temporary and occasional use where rapid heating is required but precise temperature control is not.

High-Temperature Constant-Wattage
Heaters for Pipes and Tubes

Rated for a maximum heat output of 900° F, these heaters are often used for thawing frozen pipes and rapid spot heating.

Cut-to-Length Constant-Wattage
Heaters for Pipes and Tubes

With a cable that supplies the same wattage along the entire length, these heaters remain consistent regardless of the surrounding temperature. All require a temperature switch or controller to regulate heat output.

Cut-to-Length Self-Regulating
Heaters for Pipes and Tubes

Also known as self-regulating heat cable, these heaters automatically adjust heat output at different points along their length to account for differences in environmental temperature.

Ultra-High Temperature Constant-Wattage
Heaters for Pipes and Tubes

For demanding applications such as hot-melt transfer pipes, these heaters have a maximum heat output of 1400° F.

Pipe Thawers

Thaw pipe without direct access to or knowing exactly where the frozen section is.

Wire and Cable

High-Temperature Wire

Even at 480° F—hotter than some industrial ovens—this wire’s insulation won’t melt.

High-Voltage Wire

Use this wire in high-voltage applications that require 10,000 volts DC or greater, such as in high-power signs and lasers.

Abrasion-Resistant Wire

Run power over rough surfaces—this wire has thick insulation that stands up to wear and tear.

High-Temperature Cable

For high-heat applications such as furnaces and ovens, this cable's insulation withstands temperatures of 390° F and higher.

Appliance Cable

Also known as zip cord, this cable is often used in lamps, heat guns, and other small appliances.

High-Temperature Continuous-Flex Cable

Bend and flex this silicone-insulated cable in temperatures up to 350° F. It can keep moving in areas twice as hot as most other continuous-flex cables without degrading data or signal transmission.