Create an undersized hole so concrete tapping screws fit tightly once they're threaded into place. These bits are slightly smaller than the matching screw size. They have a carbide tip that resists wear and heat to stay sharp.

No need to move the hole when you encounter rebar in concrete—swap out your masonry bit for one of these cutters. They have a carbide tip that resists wear to stay sharp. Once you're through the rebar, resume drilling with the masonry bit.

Crush rather than cut material so bits don’t jam or overheat while drilling masonry and concrete. The ultra-hard carbide tip breaks masonry into pieces and the widely spaced flutes channel them out of the hole. These bits stay sharp, resisting wear and heat that will dull or break other bits.

Instead of investing in multiple bits, change the bit body to drill a different-sized hole. These hollow bits remove a large core of material from concrete, brick, and masonry for installing pipe and conduit. The carbide tip resists wear and heat to stay sharp. Bits include a pilot drill to make starting holes easier.