Search Results
    Clear All
    Material
    Material
    Steel
    System of Measurement
    System of Measurement
    Metric
    Overall Width
    Overall Width
    Show
    28mm
    Shank Thread Size
    Shank Thread Size
    M10
    M14
    Rod End Type
    Rod End Type
    BoltBall Joint
    Shank Gender
    Shank Gender
    MaleFemale
    Shank Thread Direction
    Shank Thread Direction
    Right Hand
    Left Hand
    Overall Thickness
    Overall Thickness
    default
    14mm
    16mm
    17mm
    Shank Thread Pitch
    Shank Thread Pitch
    1.5 mm
    2 mm
    Shank Thread Length
    Shank Thread Length
    default
    20mm
    21mm
    28mm
    29mm
    36mm
    Shank Center Length
    Shank Center Length
    default
    43mm
    48mm
    75mm
    130mm
    Maximum Ball Swivel
    Maximum Ball Swivel
    default
    Less than 10°
    25° to 49.9°
    Specifications Met
    Specifications Met
    DIN 444
    DIN 648
    DIN 3405
    DFARS (Defense Acquisition Regulations Supplement)
    DFARS (Defense Acquisition
    Regulations Supplement)
    Insert Material
    Insert Material
    Steel
    Rubber
    Shank Threading
    Shank Threading
    Fully Threaded
    Partially Threaded
    Lubrication
    Lubrication
    Not Required
    Lubricated
    Static Radial Load Capacity
    Static Radial Load Capacity
    300 lbs.
    320 lbs.
    4,850 lbs.
    Ball Material
    Ball Material
    Bearing Steel
    Carbon Steel
    Seal Material
    Seal Material
    Stainless Steel
    Steel
    Insert Finish
    Insert Finish
    Zinc Plated
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)

    7 Products