Half the weight of steel, this aluminum framing resists corrosion in wet environments.

Connect T‐slotted rails and reinforce joints for structural stability.

Use hinges to add doors, lids, and machine guards to T-slotted framing.

Designed to wrap around the sides of strut channel, these brackets provide a stronger hold than other strut channel brackets.

Close off openings in structures while allowing air to pass through.

Strengthen corners of cases and crates.

Connect wood 2×4s to posts and other flat surfaces.

These brackets come in one piece that can be cut-to-size with a hacksaw.

Interlock brackets to secure panels flush to flat surfaces.

The two-piece design accommodates a wide range of panel thicknesses.

Position proximity, photoelectric, and light beam sensors and switches.

Hexagonal holes provide a large open area for high-flow applications.

Trap small particles in low-flow applications—these sheets have tiny holes and small open area.

Harder and stronger than our other aluminum perforated sheets, these sheets have greater wear resistance.

These sheets are stronger than our other plastic perforated sheets for greater impact and abrasion resistance.

Brass is softer and easier to form compared to other metals.

Thread one of these plates onto your ram and use the four mounting holes to secure it in place.

Mount workpieces in precisely located holes for repeatable setups.

Ensure accurate right angles and hold workpieces and fixtures perpendicular to a machine table by securing them to these plates with clamps.

Use the tapped holes to mount your work.

Also known as vacuum chucks, these plates secure thin and flexible parts that can’t be held with vises or clamps for milling, drilling, routing, and finishing operations. Connect the system to your shop’s compressed air supply and it's ready to use.

Add a flat mounting surface to to a screw jack to support loads.

Install these mounts on machines without feet.