Slide thin sheets of material into the included die block then punch an inner and outer hole to create a shim or washer.

Cut DIN-size holes in steel up to 7/64" thick using a driver ram and hydraulic pump.

The driver supplies eight tons of force to the hole punches in this set to make straight punches.

Create larger holes and make repeated punches with these drivers that supply 11 tons of force to the included hole punches.

A locking clamp eliminates the need to thread the punch onto the stud, making setup and disassembly quicker than with standard punches.

Use twice the punching force of standard extended-reach punches to make holes in structural steel channels and angle iron.