Attach two punch heads to the handle at the same time to punch a gasket or washer in a single strike.

Slide thin sheets of material into the included die block then punch an inner and outer hole to create a shim or washer.

Create holes for installing heavy duty industrial connectors. When the die and punch are pressed together, four centering mandrels in the die mark where to drill holes for the connector's assembly.

Use a wrench to cut DIN-size holes in steel up to 1/16" thick.

The driver supplies eight tons of force to the hole punches in this set to make straight punches.

The included hydraulic driver allows you to punch conduit up to size 2.

A locking clamp eliminates the need to thread the punch onto the stud, making setup and disassembly quicker than with standard punches.

About half the size of a standard portable lever-operated punch, these punches can fit in your toolbox.

Deliver nearly three times the punching force of a standard portable lever-operated punch by holding one handle and turning the other 360°.

Use twice the punching force of standard extended-reach punches to make holes in structural steel channels and angle iron.

Our most powerful lever-operated punch, the rotary-action socket turns to deliver two to three times the punching force of other bench-mount lever-operated punches.

These standard saws have high-speed steel teeth.

Specially designed teeth cut faster than the teeth on standard hole saws.

The carbide-tipped teeth on these saws last up to twice as long as high-speed steel teeth.

The carbide teeth on these steel saws cut hard metal such as steel, stainless steel, cast iron, and titanium.

Make clean, fast cuts in thin metal and plastic when you use one of these saws with an impact driver. The body widens at the top to prevent the saw from pushing through your workpiece.

The carbide teeth on these steel saws cut aluminum, brass, bronze, steel, and plastic sheets and last up to twice as long as high-speed steel teeth.

Use these saws with a drill press to cut a variety of hole sizes in sheet metal.

The saws in these kits have carbide-tipped teeth, so they last up to twice as long as saws with high-speed steel teeth.

Combine the cutting base and a corner punch to make rounded corners in sheet metal.