Use these punches to make round holes up to 1" dia. in fabric, leather, and rubber.

Slide thin sheets of material into the included die block then punch an inner and outer hole to create a shim or washer.

These standard saws have high-speed steel teeth.

Lower cutting depths than standard hole saws make these saws less likely to rip or tear while making smooth, burr-free cuts in sheets.

Fit the punches in these sets through existing holes and mark the center of the hole in a second workpiece.

These sets come with three punches for use with a variety of hole sizes. Insert one into an existing hole and twist the handle to open the end of the punch. The point automatically centers once the punch has fit the hole size.

Push down on the spring-loaded cone to center the punch in a variety of round and square hole sizes.

Also known as transfer screws, the punches in these sets can be used in any threaded hole to transfer the hole location. Use the handle to screw a punch into a hole.

Push parts out of molds with these hardened pins. Also known as knockout and forged pins.