These hooks are often used to hang coats and other lightweight items.

Attach these general purpose hooks to steel walls, cabinets, and other magnetic surfaces.

Adhesive strips hold tight yet remove cleanly without damaging the wall.

Quickly mount these hooks with a few strikes of a hammer.

Racks have multiple holders to organize items.

With threads on one end, holders can easily be screwed into a wall.

A locking tab and mounting screw secure holders on hardboard pegboard to store tools such as pliers, screwdrivers, and hammers.

Hang wrenches, handsaws, levels, and other tools on these hooks.

Assortments include enough pieces to set up an entire pegboard.

These rotate for easy positioning before a load is applied.

A ball-bearing swivel allows these to rotate under load. Attach to chain by inserting the included pin through a link.

For extra security, these have a latch that snaps back into place to secure your load.

These hooks have closed ends on both sides.

Create your own lifting eye by adding an eye nut to a stud or bolt.

Use these eyebolts for routing wire and for other light duty applications.

Create fast connections with items, such as rope, chain, and straps.

Lock by screwing the latch into the body.

The narrow end restricts the movement of rope and chain, and the wide end allows room to attach multiple connectors.

Flat sides allow webbing and strapping to lay flat, so they won't slide and bunch.

Drive the end through the eye and weld or flatten the extended end to resist opening. These links are also known as cold shuts.

Attach webbing to these buckles without sewing.

These slides are rated for heavy duty applications.

Use these plates where full lengths of track won't fit to create one anchor point.

The thick wire coil on these hooks makes them stronger than standard hooks.

Keep multiple bundles of wire and cable on separate hooks. The hooks have wide openings to allow access for installation, adjustment, and removal.

Anchor these ringbolts where you need them, then remove the ring when not in use. Once installed, the mounting bolt stays in place. Insert the ring by threading into the mounting bolt; remove by unthreading it.

Organize multiple lines of pipe, tubing, and conduit with one clamp. Wider than standard loop clamps, multiline loop clamps surround two lines of material to create a secure grip while holding the lines close to the mounting surface. A cushion covering the clamp reduces vibration and wear from clamp edges.

For use with a single line, these clamps brace pipe, tubing, and conduit directly against the mounting surface.

Hold pipe, tubing, and conduit away from strut channel.

Secure insulated pipe to strut channel without pinching the insulation or exposing the pipe. These clamps are sized for use with insulated pipe and have a plastic insert that creates a seal around the insulation to prevent the pipe from sweating, which can cause mold and corrosion.

Even when these clamps are installed side by side, the clamping screws remain accessible. Use them to route pipe, tubing, and conduit across strut channel.

A rubber cushion reduces vibration and wear from clamp edges. The cushion also protects lines of pipe, tubing, and conduit from corrosion caused by metal-to-metal contact.

These latches are reversible for right- and left-hand mounting.

Designed to stand up to heavy use, these latches are often seen on refrigerators and truck doors.