This optional tool offers a quick and easy way to connect large quantities of barbed fittings to push-on hose. Use the built-in cutter to squarely cut push-on hose without fraying. Then, clamp the hose into the tool’s vise and apply light pressure on the handle to drive into the fitting.

Sets contain a crimping tool and a variety of CGA fittings, nuts, and ferrules so you can connect pressure regulators, torches, and other components of your welding system.

With the most leverage of any of our installation tools, this tool has a ball handle that makes it easier to ratchet.

Use to tighten low-profile band clamps, then break off the excess banding.

Crimpers are furnished with five removable dies that crimp air and water hose.

Use a hammer strike or a vise to crimp ferrules onto your hose and secure barbed hose fittings.

Turn the lugs on fire hose fittings and the fasteners on hydrants.

The 5-point opening fastens the nuts and caps on fire hydrants. These wrenches have a ratcheting mechanism that allows you to turn fasteners without removing and repositioning the wrench.

Grip hose and tubing for installation and removal without damage.

Cut plastic and rubber pipe, tubing, and hose.

Slice through thick plastic pipe up to 2” in diameter in only three seconds.

Cut plastic and rubber tubing from your bench top.

Avoid tiring your hand while making repeated cuts in a variety of material—from plastic pipes to wood dowel pins.