The tapered barrel on these bushings is split on both sides, allowing them to contract more tightly around the shaft than quick-disconnect and taper-lock bushings.

Mount these hubless bushings flush into your sprocket or pulley for a slim profile with no protruding screws.

Also known as Trantorque bushings, these tighten with a twist of the collar nut—no screws needed.

Made from stainless steel or plated with nickel, these bushings resist corrosion. A mounting flange prevents movement during tightening.

Insert these nickel-plated steel bushings into the bore of your sprocket for flush or recessed mounting in wet environments.

Tighten just one set screw to clamp these bushings evenly around your shaft. The screw forces hydraulic fluid in between the double-walled sleeve, expanding the two walls against the shaft and the hub of your sprocket, pulley, or gear for a tight hold.

Unlike most bushings, these won’t buckle the material or distort the hole when installed in thin-gauge aluminum and steel fixture plates.

Prevent removable drill bushings from pushing through fixture plate holes as you machine. Quick to twist on and off, these lock rings make it easy to secure and remove bushings.

Serrations on these bushings dig into wood, aluminum, and other soft metals to keep them from spinning while you drill. Also known as jig bushings, they fit inside fixture plates to guide drill bits, counterbores, and reamers.

Serrations line the sides of these bushings to keep them from spinning while you drill. Also known as jig bushings, they’re pressed or molded into plastic tooling to guide drill bits, counterbores, and reamers.