We will reply to your message within an hour.
More
The tapered barrel on these bushings is split on both sides, allowing them to contract more tightly around the shaft than quick-disconnect and taper-lock bushings.
The screw connections on these bushings easily mate to compatible quick-disconnect sprockets and pulleys.
Mount these hubless bushings flush into your sprocket or pulley for a slim profile with no protruding screws.
A mounting flange prevents movement during tightening.
Insert these bushings into the bore of your sprocket for flush or recessed mounting.
Also known as Trantorque bushings, these tighten with a twist of the collar nut—no screws needed.
Each hub includes a set screw (unless noted), which bites into your shaft to hold the coupling in place.
The thick split spider on these couplings takes on twice as much torque as standard split spiders, while a set screw holds the hubs in place on your shaft. Also known as jaw couplings, use them to connect motors to pumps, mixers, and other high-torque equipment.
Each hub includes a set screw, which bites into your shaft to hold the coupling in place.
Designed to grip evenly around your shaft, these couplings provide more holding power than set screw couplings without marring the shaft.
Also known as Schmidt couplings, these handle higher angular misalignment than other three-piece couplings. Good for applications with varying shaft misalignment, they're commonly used with conveyor rollers and roller feeds in printing and packaging machines.
Safely connect slightly misaligned shafts near food lines—the spider on these couplings contains metal, so it’ll trigger a metal detector if a piece frays off and contaminates your batch.
Use these gear-shaped couplings for high-speed and high-torque applications.
Made with lightweight nylon sleeves, these gear couplings require less energy to move than other high-torque flexible couplings. They compensate for parallel, angular, and axial misalignment.
Instead of replacing your shaft or keeping components, such as couplings, with various bore diameters on hand, these reducers adapt the bore of a component to a smaller size.
A bolt in each corner makes for a secure, even hold.
Made to withstand frequent washdowns, these bearings are permanently lubricated, which means you’ll never have to add lubricant. Use them in hard-to-reach areas in food, beverage, pharmaceutical, and chemical plants.
The tapered rollers in these bearings support large shafts at high static loads.
Ball bearings operate with less friction than other bearings, so they can run at higher speeds.
Meeting IP69K for washdown environments, these mounted ball bearings are used in food, beverage, pharmaceutical, and chemical plants.
Also known as tapped-base bearings, these ball bearings mount to surfaces from the bottom through threaded holes. Because of their narrow profile, they’re commonly used in tight-clearance spaces, including systems where multiple shafts are mounted close together.
Roller bearings have a thinner profile and larger contact area than ball bearings, making them stronger and more space-efficient than ball bearings.
Ball bearings operate with less friction than other bearings, so you can run them at higher speeds.
Used in food, beverage, pharmaceutical, and chemical plants, these mounted ball bearings are IP69K certified for washdown environments and have a two-bolt flange for mounting.
Permanently lubricated and IP69K certified for washdown environments, these mounted ball bearings are useful for hard-to-reach areas in food, beverage, pharmaceutical, and chemical plants. Mount them using their two-bolt flange.
Rated IP69K for washdowns, these bearings stand up to frequent cleanings in food, beverage, pharmaceutical, and chemical plants.
Combine with threaded pipe to mount these bearings in a variety of positions without the need for a flat mounting surface.
Swap out worn inserts instead of replacing the entire mounted unit.
Slip these bearings onto a shaft and secure with the included set screws, no special tools required.