With a small body size, these cylinders fit into tight spaces but offer similar push forces to standard hydraulic cylinders.

Small yet powerful, these cylinders thread into a system for workholding applications.

These kits include the rod gland with all of the seals installed.

Jacks include a ram, a hand pump with hydraulic oil, a pressure gauge, and a hydraulic hose.

Connect up to four rams and a gauge to a pump. Ram connections have flow-adjustment valves to adjust ram speed, or shut it off to temporarily hold a load.

Connect these pumps to a ram to create a hydraulic jack.

Connect a hose to a ram or pump.

Thread one of these plates onto your ram and use the four mounting holes to secure it in place.

Pump the handle by hand to raise the jack. Turn the release valve to lower the load.

Use these versatile jacks for lifting, spreading, bending, pushing, and straightening.

These jacks have a short body to fit in low-clearance spaces. The handle pumps from side to side, requiring less vertical space than other bottle jacks.

As versatile as bottle jacks, but with two lifting points—a toe for lifting loads low to the ground, and a saddle for a higher, more stable lifting point.

Roll from job to job and under hard-to-reach places.

PTFE gives these seals a slippery surface that allows rod speeds more than two times faster than our other piston seals.

These Buna-N seals are reinforced with cotton thread for strength.