A magnet holds the fastener securely enough to drive self-tapping screws.

With a smaller OD than standard sockets, these fit between tightly spaced fasteners.

Extra length allows access to fasteners on long bolts.

Attach these sockets to your spline-drive impact wrench.

Made of aluminum-bronze, these sockets satisfy OSHA requirements that specify nonsparking tools for locations where flammable vapors and combustible residues are present.

Quickly position these sockets on square fasteners.

Made of aluminum-bronze, these sockets satisfy OSHA requirements that specify nonsparking tools for locations where flammable vapors and combustible residues are present.

The slotted shape of these sockets fits over wing nuts to tighten and loosen them with more force than you can by hand.

The short bit on these sockets fits in spaces where height clearance is limited.

These sockets fasten Torx screws often used in vehicles, bicycles, and electronics.

Extra-long bits help you access hard-to-reach fasteners.

A magnet holds the fastener securely enough to drive self-tapping screws.

Pivot the head to access fasteners from an angle.

Carry fewer impact sockets—these five reversible impact sockets turn 10 fastener sizes. Flip the socket around to turn a different size.

Turn square-drive fasteners in several sizes with these socket sets.

Use these sockets as an alternative to a screwdriver or L-key. They are made to withstand the high torque and force of impact tools.

Pivot the head to access fasteners from an angle.

Remove and install dual wheels on trucks and trailers with the sockets in these sets.

Convert your standard 6-point sockets into hex bit sockets with these bits.

The hole in the middle of these bits fits the security pin in tamper-resistant Torx screws.

A magnet holds the socket, making changes quicker.

Attach to your socket for a longer reach.

Attach one of these extensions to your impact socket to turn fasteners in hard-to-reach spaces.

Also known as positive-locking extensions, these extensions hold sockets place with a ball that only retracts when you pull the collar down. Designed to prevent accidental detachment, they lock to your socket more securely than other extensions.

Pull the collar to quickly attach and remove sockets.

Convert your impact socket into a flex socket to access fasteners from an angle.

Use the pulsing of an air hammer along with the controlled turning of a hand wrench to release stuck fasteners without breaking them.

Attach your square-drive sockets to drills, powered screwdrivers, and other tools that accept a hex shank.

These adapters, which convert from one square drive size to another, were designed to tolerate continuous use with impact tools in high-volume production and assembly.

Use these adapters to connect sockets to impact wrenches and other power tools—they’re designed to tolerate continuous use in high-volume production and assembly.