Use these attachments to mount indicators in chucks, tool posts, height gauges, or a variety of other setups.

For more versatility than other low-profile holders, this holder has six locations for mounting indicators and accessories, including two mounting holes and four places to mount an indicator lug back with the included thumb screws.

Use a swivel clamp to attach an indicator to the positioning arm.

Adjust the flexible arm to nearly any position.

Attach the C-clamp on this holder to your Bridgeport J head to take indicator measurements without obstructing the cutting tool.

Mount these holders into a machine spindle and use with your indicator to center workpieces.

Position the arm by adjusting joints at the top, middle, and bottom.

Install a test indicator on each holding rod to check for shaft misalignment.

Two chain clamps position two test indicators at different points along a shaft to find any misalignment.

Use stylus movement to check for misalignment. Kits include two sets of mounting brackets with adjustment knobs.