Make a custom panel light with your choice of light and lens cap color.

Rated NEMA 4X and 13 for protection from dirt, washdowns, corrosion, and oil/coolant spraying.

Lights have a watertight O-ring seal.

The pad below the base absorbs shock and vibration.

Direct your signal with these lights; they flash in one direction.

These lights cycle through three different flashing patterns.

Place these lights in full sun and their batteries charge during daylight hours. Lights automatically switch on at dusk and off at dawn.

Easier to spot than other strobe lights, these lights emit bursts of multiple flashes.

These strobe lights flash multiple times per cycle, making them easier to spot than standard strobe lights.

As small as a hockey puck and compatible with standard 12-volt vehicle plugs, these strobe lights are inconspicuous when not in use and quick to connect.

Screw into a standard medium-base light socket.

Mounted on a tripod, these lights stand higher for greater visibility than other strobe lights.

Carry these lights around with you and place them wherever needed. They can switch between being continuous or flashing.

Mount these lights to the top of towers to warn low-flying aircraft.

The buzzer warns workers of hazards even when they’re outside a direct line of sight.

The revolving motion of the light makes these more visible than flashing lights.

These lights have lenses that snap in and out, so you can easily swap colors or change their position in the stack.

Choose from seven colors, including nontraditional colors such as magenta and turquoise, for a custom four-light stack light.

Use these lights in tight spaces in place of a tower. They emit three colors from a single lens.

These lights emit three colors from a single lens and can be mounted in tight spaces where a tower will not fit.

These lights have LED bulbs for years of maintenance-free operation and can be wired as either continuous or flashing.

Get notified about equipment issues even when you aren't around your machines. These lights connect to your computer via Ethernet, allowing you to set up email alerts when there is a problem with a machine, server, or conveyor.

When motion is detected from both directions at a two-way corner, these lights flash to alert personnel and prevent collisions.

Bulbs have two filaments, which operate at different brightness levels.

Wire terminals allow you to connect these bulbs to a power source through a panel.

These bulbs are sized to fit tight spaces such as indicators and vehicle lights.

Use these bulbs in tight spaces, such as in indicators and vehicle lights.

Commonly used in signs, instruments, indicators, and flashlights.

Use these as replacement bulbs in stack lights.

Pins on the base lock these bulbs into sockets to withstand vibration.

You can fill these with water for added stability and drain when not in use for easy transport.