The tapered shape makes it easier to guide these inserts into a hole during installation. Use a drill bit to create a straight hole, then taper the top half.

Install these inserts into plastic parts to create a secure base for fasteners.

Made from brass, these inserts are electrically conductive, nonmagnetic, and have good corrosion resistance.

These aluminum inserts are 70% lighter than brass inserts, electrically conductive, and nonmagnetic. They have good corrosion resistance, which is comparable to brass but not as good as stainless steel.

These 18-8 stainless steel inserts have better corrosion resistance than brass inserts and may be mildly magnetic.

The flange keeps these inserts from pulling through a hole. Press them in from the underside of material, and install a screw from the top of material.

These 18-8 stainless steel inserts have better corrosion resistance than aluminum inserts and may be mildly magnetic.

The barbed sides keep these securely in place even before a screw is installed.

Made of 18-8 stainless steel, these inserts have good corrosion resistance.

A dry film keeps the screw from sticking or binding in these inserts during installation.

Made of nickel alloy, these inserts are more resistant to acids and salt water than stainless steel inserts.

Without a prong to break off and retrieve, these inserts are often used where debris could cause damage.

Inserts come with a through-hole tap and installation tool.

A black-phosphate finish provides mild corrosion resistance.

These inserts are the most corrosion-resistant thread-locking inserts we offer.

Made from brass, these inserts are nonmagnetic, mildly corrosion resistant, and electrically conductive.

Press these metric nuts into a drilled or punched hole with an arbor press or similar pressure tool.

A flat hex head sits flush against the material surface for use in low-clearance applications.

Stainless steel press-fit nuts have excellent corrosion resistance in most environments.

These press-fit nuts are tin plated to resist corrosion from chemicals and salt water.

About twice as strong as aluminum rivet nuts, these low-profile rivet nuts have a cadmium or tin-zinc plating for corrosion resistance.

These low-profile rivet nuts are one-third the weight of steel and have mild corrosion resistance.

Weld these metric nuts to flat and uneven uncoated steel surfaces for a strong permanent hold.

Stainless steel nuts have excellent corrosion resistance in most environments.

18-8 stainless steel studs have good chemical resistance.

Place the tip of these tools into an insert and strike them with a hammer to drive the keys into the material. They’re compatible with Keensert® inserts.

Screw an insert onto these tools and drive them a quarter to half-turn below the material's surface. They're compatible with helical inserts that have a prong.

Place the tip of these tools into an insert and strike a light blow to the tool’s head. Then turn the tools counterclockwise with pressure to extract the insert.

Thread these tools into an insert and turn counterclockwise to extract.