Made of aluminum with a fiberglass liner, this sleeving reflects heat away from contents and withstands temperatures up to 390°F. A slit along the entire length makes it easy to install around wire, cable, and hose without disconnecting them.

Seal fiberglass duct and insulation that's faced with an all-service jacket (ASJ). Tape is reinforced with fiberglass.

Seal foil-jacketed insulation as well as air-conditioning and refrigeration systems with this conformable aluminum tape.

This polyester tape has a woven mesh edge that conducts electricity. Use it to shield cables and electronic components from EMI (electromagnetic interference).

Use this tape to attach components to heat sinks and metal chassis walls in place of screws and other mechanical fasteners. It conducts heat away from sensitive electronics.

Cover small spots and holes while paint stripping and electroplating, or use as a moisture and dust barrier. These aluminum foil discs are flexible and conform to irregular shapes.

The threshold height can be adjusted to ensure a tight fit under a door.

With a ribbed top, these thresholds offer more slip resistance than smooth-top thresholds.

The middle of these three-piece thresholds can be installed smooth or ribbed side up for more slip resistance.

Create a gradual incline between uneven floor surfaces. These ramps are good for allowing wheelchair access.

Made of aluminum or stainless steel, this trim withstands heavy impact for maximum surface protection. It's often used on panels, boards, signs, and mirrors to protect the edges.

Also known as door plates, armor plates, and mop plates, kick plates protect the base of a door from damage caused by foot traffic and equipment.

These aluminum bases provide more impact protection than plastic bases. In addition to protecting the bottom of a wall from damage, they create a finished look where the wall meets the floor. They're commonly used in warehouse and manufacturing areas.

A honeycomb core is bonded between two aluminum sheets for rigidity.