We will reply to your message within an hour.
More
Wings provide more leverage than spade-head thumb screws for greater torque while tightening. A zinc plating provides corrosion resistance in wet environments.
These metric thumb screws have wings that provide more leverage than spade-head thumb screws for greater torque while tightening. A zinc plating provides corrosion resistance in wet environments.
These metric thumb screws have arms that provide a flat surface to push your fingers against.
These steel screws are zinc plated to resist corrosion in wet environments.
Made from 410 stainless steel, these screws are strong, wear resistant, and mildly chemical resistant.
A Torx drive has more points of contact than a Phillips drive, allowing you to apply extra force with less slippage or damage to the recess.
These steel screws cut threads in drilled holes as they’re turned, so they require less driving torque and cause less stress on your material than thread forming screws.
A wide cutting slot provides excellent chip clearing and low driving torque in soft metal.
These screws have a hex head for a secure grip with a wrench.
Also known as Swageform screws, threads at the tip are designed to grab material for a fast start with low torque in a wide range of materials.
Add an eye nut to threaded rod to hang the rod from rings, hooks, and hangers.
Choose between two lifting points—use the toe for lifting loads low to the ground, or use the saddle when you need a higher, more stable lifting point.
These jacks can be used to lift, spread, push, pull, and clamp.
Wrench-adjustable jacks require less clearance to turn than bar-adjustable jacks.
The turning bar gives you leverage to lift heavier loads than wrench-adjustable screw jacks.
Found in hand-powered clamps, vises, grates, doors, and work tables, lead screws and nuts have broad, square threads that are well suited for quick assembly, high clamping forces, and lifting and lowering heavy objects.
Also known as single-start and self-locking lead screws and nuts, these have a single thread that runs the length of the screw. The nut travels only when the screw turns, so your system won't unexpectedly move when the lead screw is at rest.
Multiple thread channels (also known as thread starts) create faster linear travel than lead screws with a single thread start.
Broad, strong Acme threads make these screw jacks better than ball screw jacks for heavy loads, intermittent positioning applications, and where vibration is present.
Low-friction ball bearings allow these screw jacks to use half the power required by an Acme screw jack to lift the same load. Typically used as actuators, they run at higher speeds than Acme screw jacks.
Combine fast-threading components to build a clamping assembly.
To provide corrosion resistance in wet environments, this framing is galvanized.