Precision ground to a tight diameter tolerance, these rods are ready for turning in your lathe.

With a high amount of ferrite, these cast iron rods are easier to machine without cracking than other impact-resistant ductile cast iron rods. Use them to create bushings, gears, pulleys, and pistons.

The premium abrasive stays sharp longer.

The premium abrasive stays sharp longer.

The premium abrasive stays sharp longer.

The premium abrasive stays sharp longer. Holes in the disc let you see the surface you’re sanding.

With more flaps than standard discs, these last 30-40% longer.

The flaps have an abrasive to remove material and a lubricant that minimizes heat to reduce discoloration of the work surface.

Set at an angle and widely spaced, the flaps reach into corners.

Multiple layers of nylon mesh embedded with abrasive provide a cushioned grind. Also known as unitized discs or wheels.

A more durable abrasive allows these wheels to remove more material and last longer than Norton General Purpose Grinding Wheels. They are also known as Type 1 wheels and straight wheels.

The porous bond leaves more space between abrasive grains so heavy amounts of chips and coolant easily flow through.

Use these wheels for heavy material removal in one spot or along a weld seam. They are also known as Type 1 wheels and snagging wheels.

Set contains a selection of our most popular hex-shank grinding bits. Use them in any drill chuck that accepts a 1/4" hex shank.

The small 3/32" diameter shank and small head makes these bits good for precise and intricate jobs.

Similar to diamond, boron nitride is harder than aluminum oxide and lasts longer. Bits are also known as jig grinding pins and mandrels.

Lap without the mess of pastes and slurries—abrasive is embedded in the surface of this waterproof film.

Also known as Type 27, raised-hub, and depressed-center cutoff wheels, these wheels outperform Type 1 wheels when making flush cuts in aluminum, iron, stainless steel, and steel.

Made of premium grade abrasives, these wheels are strong and thick for making notches in aluminum, iron, stainless steel, and steel.

Run these high-density aluminum oxide wheels at higher speeds than standard cutoff wheels to make quick cuts in aluminum, iron, stainless steel, and steel.

These high-density ceramic oxide wheels have two layers of fiberglass mesh reinforcement and last up to twice as long as long-life cutoff wheels when cutting aluminum, iron, stainless steel, and steel.

An extra-fine layer of fiberglass mesh reinforcement allows these wheels to make smoother cuts than standard bench-grinder cutoff wheels when cutting metal such as aluminum, iron, stainless steel, and steel.