Keep workers clean and protected from spills and splashes on food processing lines while reducing the risk of contaminating the food.

Keep dry in wet and rainy conditions.

Use this PTFE sleeving in applications where temperatures reach up to 500° F.

Coated with PVC, this polyester sleeving resists chemicals and solvents. It has a slit along the entire length so it easily wraps around wire, cable, and hose without disconnecting them.

A slit along the length makes this sleeving easy to install over wire, cable, and hose without disconnecting them. The corrugated construction gives it impact and abrasion resistance similar to conduit, with more flexibility.

The two halves of this sleeving nest into each other, fully enclosing contents. It has interlocking ridges that overlap to keep out dust and dirt. The corrugated construction gives it the impact and abrasion resistance of conduit, with more flexibility.

Wrap this sleeving around cable, cords and wires to protect them and to form bundles.

Made of PTFE, this sleeving has excellent resistance to chemicals and acids. A reusable alternative to tape and cable ties, it allows you to route wire and cable between the spirals.

Protect cables, cords, and wire and form them into bundles in your food-processing plant while lowering the risk of contaminating the food.

With thin walls, this tubing shrinks faster than other high-temperature tubing. It withstands up to 500° F.

Use this general purpose tubing to insulate and protect wire and cable.

Extra-thick walls provide more protection against abrasion and tears than standard high-shrink-ratio tubing. This tubing shrinks down to 1/6th of its original ID, so it creates a tight seal over irregularly shaped objects.

The smallest heat-shrink tubing we offer, this tubing protects wire with a 0.017" and smaller diameter.

Often used to bundle batteries, capacitors, and other electronics, this tubing tightly conforms to objects, similar to shrink wrap. It has excellent resistance to chemicals, oil, and acids.

After being cleaned with alcohol, this tubing is bagged and sealed in a clean room. It's certified for material quality and purity.

Extra-thick walls provide better protection against abrasion and tears than standard moisture-seal tubing, as well as creating a water-resistant seal.

This PTFE tubing withstands temperatures up to 450° F and has an inner lining that creates a water-resistant seal when heated.

Protect bus bars and other high-voltage devices—this tubing withstands voltages up to 15,000 volts.

Made of PVDF, this tubing has excellent cut and abrasion resistance. It has a flame-retardant additive that resists combustion and minimizes the spread of flames.

A layer of conductive cloth protects wire and cable from signal interference caused by nearby equipment and devices.

Organize and route wire and cable in an enclosure—this tubing bundles wires together while allowing them to reach different connection points.

Maintain a supply of tubing in a variety of sizes that withstand abrasion, moisture, and chemicals.

Also known as breakout boots, these splitters insulate and seal the point where wire splits off from cable, or where cables exit from conduit.

A different shrink ratio on each end allows this tubing to fit over cable assemblies and wire harnesses with large connections, or around connectors with a 90° elbow.

These kits insulate one P-trap and two stop valves to reduce the risk of burns from accidental contact with hot pipes under your sink. The molded, flexible pipe covers are ADA compliant when properly installed.

Typically used as duct wrap, these flexible sheets consist of polyethylene bubbles covered with aluminum polyester foil that prevent 96% of heat from radiating into or away from duct. Use on rectangular and round ductwork.