McMaster-Carr logo
    Forward
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Print
    How can we improve?
    Comments
    E-mail address (if you would like a response)
    7 Products
    About Hex Nuts
    industrial info icon

    Choose a hex nut with the right profile, material, and strength for your application.

    Thin-Profile Hex Nuts

    Image of Product. Front orientation. Hex Nuts. Thin-Profile Hex Nuts.
    About half the height of standard-profile nuts, these fit in spaces with low clearance. You can also use them as jam nuts by threading them against another hex nut to hold it in place.
    Medium-Strength Steel
    These Grade 5 or Class 04 nuts are your go-to for fastening most machinery and equipment. To avoid stripped threads during installation, make sure your screw has a comparable strength rating.
    Zinc-Plated Steel—A step up from plain steel, the zinc plating withstands occasional exposure to moisture.
    Steel—Best for dry environments since moisture will cause these nuts to rust.
    Thread Size
    Wd.,
    mm
    Ht.,
    mm
    Fastener Strength
    Grade/Class
    Specs. Met
    Pkg.
    Qty.
    Pkg.
    Zinc-Plated Steel
    M48 × 5 mm7524Class 04DIN 439B, ISO 40351000000000000000
     
    Steel
    M48 × 1.5 mm7518—DIN 936100000000000000
    M48 × 3 mm7518—DIN 936100000000000000
    M48 × 3 mm7524Class 04DIN 439B, ISO 4035100000000000000
    M48 × 5 mm7518—DIN 936100000000000000
    M48 × 5 mm7524Class 04DIN 439B, ISO 4035100000000000000
     

    Thin-Profile Bearing Nuts

    Image of System. Front orientation. Contains Annotated. Bearing Nuts. Thin-Profile Bearing Nuts.
    Image of Product. Front orientation. Bearing Nuts. Thin-Profile Bearing Nuts.
    Used in pairs or with another bearing nut, these thin-profile nuts—often called shaft nuts—hold bearings, bushings, pulleys, and gears in place on your threaded shaft or spindle. Threading two nuts tightly against each other makes it harder for vibration to loosen your assembly than if you used only one nut. For the nut closer to the bearing, position the stepped face towards the bearing. These thin-profile nuts have holes on the side, so you can tighten and loosen them with a pin spanner wrench. All meet DIN 1816, an international standard for bearing locknut dimensions.
    Carbon Steel—Carbon steel bearing nuts are strong and resist wear.
    Thread Spacing—When choosing your thread spacing, consider the precision of your application. The finer the threads, the more control you have when making adjustments.
    Thread
    Size
    Spacing
    OD,
    mm
    Wd.,
    mm
    Specs.
    Met
    Each
    Carbon Steel
     
    Stepped Face
    M48 × 1.5 mmExtra Fine
    		7513DIN 18160000000000000
     
    back to top