Precisely align drilled holes in two parts.

Install these pins in a plate or table and mate with holes in a workpiece for precise alignment.

The shoulder provides a consistent height reference point and keeps the pin from being pressed through the fixture.

A slightly undersized shank makes these pins easy to install and replace. Also known as slip-fit and lock-screw locating pins, they are held in place by a separate lock screw.

Use the handle on these retractors to extend and retract a locating pin, protecting the pin from damage in applications where fixtures move through a process, such as along a conveyor belt.

Use these buttons to support and position workpieces and fixtures from the bottom or side. Their hex shape lets you screw them into a threaded hole with a wrench or socket.

Mount through the counterbored hole with a socket head cap screw to support and position workpieces and fixtures from the bottom or side.

Set the tang in a slot below the work surface to prevent thin material from sliding underneath the face.

Sealed at the top to prevent debris from getting inside and making them seize up, these guide pins are a good choice for machining fixtures.

As the workpiece pushes against the pin head in one direction, the internal spring pushes back to hold it in place for clamping.

Lock the nose into the retracted position by pulling the knob and rotating it 90°.

Thread onto machinery or attach a knob or handle to the threaded spindle.

Install by hand or with a hex key in low-clearance applications.

A T-handle makes these spring plungers easy to grip.

A quarter turn of the handle locks these plungers in the retracted position. The smooth ball handle is easy to grip and won't catch on other parts.

A smooth ball handle is easy to grip and won't catch on other parts.

Lock the nose into the retracted position by pulling the knob and rotating it 90°.

Weld these catches in place for a strong permanent hold.

These spring plungers have a nose that is about three-times longer than standard long hex-nose spring plungers.

A flange keeps the plunger from being pushed through a hole when the ball is depressed.

Noses are up to four times longer than standard long-nose press-fit spring plungers.

Install these spring plungers with a screwdriver—they're slotted on one or both ends.

The flangeless design allows these spring plungers to mount flush with a surface.