Internal mounting bosses or mounting brackets enable you to use panels or DIN rail to mount components. Enclosures are made of nonconductive polycarbonate that resists denting, chipping, and cracking.

Aluminum enclosures are a lightweight yet durable alternative to stainless steel.

PVC enclosures are nonconductive and chemical resistant, withstanding solvents, alkalies, and acids.

With a hygienic design, these enclosures minimize spots where food, debris, and water could collect after washdowns. Use them to house and mount switches, buttons, and other components in sanitary environments.

Internal mounting bosses or mounting brackets enable you to use panels or DIN rail to mount components.

View all sides of your installed components.

Made of polycarbonate, these enclosures resist denting, chipping, and cracking better than stainless steel enclosures.

Holes in the cover allow easy installation of push buttons, switches, and indicating lights.

Small and lightweight, these enclosures are used with sensors, switches, and testing devices.

Choose a body and two matching end caps to make your own dust-tight or watertight enclosure.

With internal slots and external fins, these enclosures hold circuit boards securely and dissipate heat to keep electronics from overheating.

Holes in the cover of these enclosures allow easy installation of push buttons, switches, and indicating lights.

Make your push buttons, switches, and indicating lights more visible and ergonomic to use. Enclosures mount on either of two sides, creating a 30° or 60° slanted surface.

Inspect components without opening the cover.

Internal mounting bosses or mounting brackets enable you to use panels or DIN rail to mount components.

Holes in the cover allow easy installation of push buttons, switches, and indicating lights.

Suitable for installing in the ground or for use in wet environments, these direct burial enclosures are rated NEMA 4X and 6P for protection from dirt, washdowns, corrosion, and water submersion.

For use in hazardous locations, these enclosures are rated NEMA 7 and 9 and meet UL Class I, Divisions 1 and 2, Groups B, C, and D; Class II, Divisions 1 and 2, Groups E, F, and G; and Class III, Divisions 1 and 2.

Made of aluminum, these enclosures resist corrosion from rain, sleet, and snow. While not as corrosion resistant as stainless steel, aluminum is lighter for better mobility, and also easier to machine for custom mounting.

Rated NEMA 12 for protection from dirt and oil/coolant dripping.

A 9-volt battery fits inside a compartment in these enclosures to power testing devices and other hand-held instruments.

These cabinets accommodate up to 3,200 lbs. of equipment and have larger interiors than standard electronics cabinets.