McMaster-Carr logo
    Forward
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Print
    How can we improve?
    Comments
    E-mail address (if you would like a response)
    2 Products

    Machine Key Stock

    Cut this square or rectangular key stock to length to create a straight machine key. Straight keys are the most common type of key. Machine keys are often the same material as the shaft and other components with which they are used. To use a key as a sacrificial part, choose a softer key that will shear off when parts are exposed to excessive force, preventing damage to expensive equipment.
    Zinc-Plated 1008-1045 Carbon Steel
    Image of Product. Front orientation. Machine Key Stock. Machine Key Stock.
    Zinc-plated 1008-1045 carbon steel key stock is an economical choice with good strength and resists corrosion in wet environments.
    Oversized Tolerance—Slightly larger than the size listed in the table, oversized stock fits tightly in a keyway. Press it into place for use in high-torque applications or to replace a key in a worn keyway.
    Tolerance
    Ht. × Wd.
    Tolerance
    Rating
    Ht.
    Wd.
    Min.
    Hardness
    Each
    12" Long
    1 5/16" × 1 5/16"Oversized0.000" to 0.003"0.000" to 0.003"Rockwell B5098491A350000000
     

    Fixture Keys

    Image of ProductInUse. Front orientation. Contains Annotated. Fixture Keys. Fixture Keys.
    Image of Product. Front orientation. Contains Annotated. Fixture Keys. Fixture Keys, Rectangle.

    Rectangle

    Sized to fit with precision in machine table T-slots, use these keys to locate fixtures and vises on your machine table. They mount to the underside of your fixture or vise with a socket head cap screw.
    For Machine
    Table T-Slot Wd.
    Lg.
    Wd.
    Ht.
    Wd. Tolerance
    For Mounting
    Screw Size
    Mounting Fasteners
    Included
    Each
    Rectangle
     
    Steel
    1 5/16"1 1/2"1 5/16"1"-0.0005" to 0"3/8"
    		No8961A18000000
     
    back to top