McMaster-Carr logo
    Clear All
    System of Measurement
    System of Measurement
    Inch
    Thread Size
    Thread Size
    click to learn more about
    Show
    Diameter
    Diameter
    1/2"
    Material
    Material
    Stainless Steel
    Steel
    Zinc
    Minimum Thread Length
    Minimum Thread Length
    5/8"
    7/8"
    1"
    1 3/8"
    1 1/2"
    2"
    2 1/2"
    3"
    Screw Size
    Screw Size
    1/4"
    Threading
    Threading
    Threaded on
    Both Ends
    Anchor Type
    Anchor Type
    Female Threaded
    Thread Fit
    Thread Fit
    Class 1A
    Class 2A
    Class 2B
    Drill Bit Size
    Drill Bit Size
    3/8"
    1/2"
    Thread Type
    Thread Type
    RoHS (Restriction of Hazardous Substances)
    RoHS (Restriction of
    Hazardous Substances)
    RoHS Compliant
    REACH (Registration, Evaluation, Authorization and Restriction of Chemicals)
    REACH (Registration,
    Evaluation, Authorization
    and Restriction of Chemicals)
    REACH Compliant
    Hardness
    Hardness
    Not Rated
    DFARS (Defense Acquisition Regulations Supplement)
    DFARS (Defense Acquisition
    Regulations Supplement)
    click to learn more about
    Drill Bit Decimal Size Equivalent
    Drill Bit Decimal
    Size Equivalent
    0.375"
    0.5"
    Minimum Installation Depth
    Minimum Installation Depth
    3/4"
    1 1/4"
    Shear Strength
    Shear Strength
    Less than 500 lbs.
    500 to 749 lbs.
    Pull-Out Strength
    Pull-Out Strength
    Less than 250 lbs.
    250 to 499 lbs.
    500 to 999 lbs.
    Sleeve Material
    Sleeve Material
    Zinc
    Stainless Steel
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)
    20 Products