These hinges are made of metal.

A grease fitting makes these hinges easy to lubricate.

Plastic hinges are a lightweight alternative to metal hinges and provide smooth, silent operation.

Hinge leaves fit into two cutouts (mortises) to mount flush with the door and frame.

These hinges are made of metal.

Tighten or loosen an adjustment screw to change the hinge resistance.

Eliminate slamming lids—these hinges hold lids open at their widest angle and then slowly pull them closed.

Only one cutout (mortise) is needed for these hinges—the offset design allows surface mounting the door leaf and mortise mounting the frame leaf.

Springs in these hinges with holes automatically swing doors and gates closed behind you.

After a light push on the door, springs in these hinges swing doors and gates fully open.

A stop keeps these hinges open at a set angle; push past the stop to open them to 180°.

A keeper holds the pin in a retracted position to make reconnecting doors easier than other pull-release quick-disconnect hinges.

Squeeze the hinge handles together to retract the pin and disconnect a door; release the handles and the pin snaps back.

To make reconnecting doors easier than other pull release quick disconnect hinges, these have a keeper that holds the pin in a retracted position.

The mounting hole pattern does not follow an industry standard, which means you can work around worn mounting holes when replacing template hinges.