Choose a Category
    System of Measurement
    System of Measurement
    Inch
    Metric
    Diameter
    Diameter
    3"
    4"
    5"
    6"
    8"
    10"
    12"
    15"
    For Maximum Workpiece OD
    For Maximum Workpiece OD
    2 15/32"
    3 5/32"
    3.54"
    5.51"
    7.87"
    Grip Style
    Grip Style
    Inside
    Outside
    Center Through-Hole Diameter
    Center Through-
    Hole Diameter
    5/8"
    7/8"
    1.28"
    1.78"
    2.37"
    Material
    Material
    Steel
    Aluminum
    For Maximum Workpiece ID
    For Maximum Workpiece ID
    2 3/4"
    3 35/64"
    3.74"
    5.91"
    7.09"
    For Holding
    For Holding
    Workpieces
    Collets
    For Lathe Chuck Diameter
    For Lathe Chuck Diameter
    4"
    5"
    6"
    8"
    10"
    12"
    15"
    18"
    5"-8"
    6"-10"
    8"-12"
    DFARS (Defense Acquisition Regulations Supplement)
    DFARS (Defense Acquisition
    Regulations Supplement)
    For Minimum Workpiece OD
    For Minimum Workpiece OD
    5/64"
    0.08"
    0.31"
    0.39"
    For Minimum Workpiece ID
    For Minimum Workpiece ID
    63/64"
    1 3/16"
    1.42"
    2.17"
    Mounting Hole Center-to-Center
    Mounting Hole
    Center-to-Center
    0.787"
    0.984"
    1.181"
    1.693"
    Slot Width
    Slot Width
    0.472"
    0.551"
    0.63"
    0.827"
    0.866"
    Thread Size
    Thread Size
    click to learn more about
    For Screw Size
    For Screw Size
    M10
    M12
    M16
    M20
    For Slot Width
    For Slot Width
    0.472"
    0.551"
    0.63"
    0.827"
    0.866"
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)

    91 Products