This wire rope provides a good balance of abrasion resistance and flexibility.

More wires per strand than other wire rope provides the flexibility required for repeat bending over drums and pulleys.

Use this wire rope when lifting in areas that are frequently washed down and require a rope that counteracts rotation.

This wire rope provides a good balance of abrasion resistance and flexibility.

These compression sleeves are designed to meet lifting specifications.

Install these stud-end plug-lock fittings on the end of wire rope for a strong hold and finished appearance.

Install these eye-end plug-lock fittings on the end of wire rope for a strong hold and finished appearance.

With a reinforced loop, also known as a thimble eye, installed on one end, quickly attach a hook or a shackle to a wire rope.

The galvanized finish resists corrosion.

For use in washdown environments, this wire rope has better corrosion resistance than the galvanized steel wire rope.

A stop, also known as a ferrule fitting, installed on one end holds the rope in place.

Screw the pin into position by hand for quick installation and removal. They're for use in low-vibration applications where the shackle remains stationary.

A bolt fastened with a nut and cotter pin makes these shackles more secure than screw-pin shackles.

One end has a bolt fastened with a nut and cotter pin for a more secure connection than flush-pin connectors.

The strongest shackles we offer, these connectors have a pin with flush ends that prevents snagging and accidental disengagement.

Smaller than lifting oblong links, these provide room for snaps, carabiners and other nonlifting connectors.

Providing better load distribution and alignment than single oblong links, these reduce wear in three and four leg slings.

Also known as hammer locks, assemble by hammering a pin through the center.

The pear-shaped link provides more room for attachments than standard figure-eight connectors.

A latch ensures rope, chain, and fittings won't separate from the hook when the load slackens.

Rotating for easy positioning before a load is applied, these have a latch to ensure that rope, chain, and fittings won't separate from the hook when the load slackens.

These rotate for easy positioning before a load is applied. They have a latch to ensure rope, chain, and fittings won't separate from the hook when the load slackens.

For a more secure connection than standard hooks, the latch locks closed when a load is applied.

These hooks swivel under load. They have a latch locks closed when a load is applied for a more secure connection than standard hooks.

Screw these hooks into place and secure with the included nut.

These rotate for easy positioning before a load is applied.

Insert in eyes, links, rings, and other connectors with small openings. Also known as J-hooks.

Pop the clevis pin in to install these hooks, no extra fittings needed.

Also known as foundry hooks, use these on thick molds, castings, and objects that don't have attachment points.

These kits fit most hooks with a drilled pinhole.

Minimize twisting and knotting of rope and chain and adjust the position of a fitting or an object under load.

Designed for angular lifting, hoist rings resist stresses that would bend or break an eyebolt. They have a lifting ring that pivots 180° front to back to compensate for roll and sway when lifting heavy or unbalanced loads.

Remove the shackle after lifting while keeping the base installed for future use.

Because it's made of a high-performance aramid also known as Technora, this rope keeps its strength in temperatures up to 300° F and is chemical and corrosion resistant.

Strong even when wet, this rope is a high-performance polyethylene also known as Spectra.

For more control over your load, this rope is a high-performance polyester also known as Vectran, which has excellent resistance to stretch and slip.