Often used in large, open workspaces, these switches can be wired on opposite ends of the room to control lights on the same circuit. They're also known as three-way and four-way switches.

Also known as three-way switches, these are often used in large, open workspaces and can be wired on opposite ends of the room to control lights on the same circuit.

Prevent accidental activation—these switches require a key to turn lights on and off.

Secure sensitive lighting equipment; these switches have a round key that is difficult to duplicate.

Control lights on a single circuit from more than one motion-sensing switch.

Rated IP65, these controls are protected from washdowns.

Screw these controls into a light bulb socket.

Adjust the brightness of lights.

Control two devices and delay the shut off of one device by up to one hour. These switches are often used with lights and fans for ventilation.

Push and release the button to activate—no electricity required.

The large face makes these switches easy to read from a distance.

Program these switches to turn a device on and off at a set time and day.

Mount these switches to a flat surface or attach to DIN rail.

Install these switches in a panel cutout.

Control equipment with high currents, such as landscape lighting, pumps, and heaters.

For precise control of high-current equipment such as landscape lighting, pumps, and heaters, these switches schedule on/off times to the exact minute.

Immediately cut power with a single push.

Use these switches where ignitable gas and dust may be present. Their contact blocks are UL listed for Class I, Division 2, Groups B, C, and D hazardous locations.

Rated NEMA 3S, NEMA 4X, NEMA 13, and IP66, these plastic switches resist corrosion better than aluminum switches and withstand washdowns and oil/coolant spraying.

A red light flashes when the actuator is pushed, making it easy to see from a distance. They're rated IP65 for protection from washdowns.

Alternate between two batteries without interrupting power.

Use fingerprints to confirm the identity of personnel before granting access to secure areas or equipment.

Set these switches to delay activation by up to five seconds after detecting an object.

Light beams travel up to 32 ft. between the transmitter and receiver.

These switches have a receiver built into the housing, eliminating the need to align components and measure sensing distance during installation.

With a narrow, flat body, these switches fit in tight spaces.

Safely detect the presence or absence of an object moving at high speeds with a light beam. These switches produce a low-current, low-voltage NAMUR signal, so they won’t create sparks or ignite. ATEX and IECEx certified, they protect against explosion in environments containing flammable gases and combustible dust.

Set these switches to delay activation by up to fifteen seconds after detecting an object.

Replace access door hinges with these switches; they actuate when the door opens at least 4°.

A raintight NEMA 3R rated enclosure protects these switches outdoors.

Install these switches in a panel cutout.

Mount these switches inside your enclosure to prevent it from opening when power is on—actuating the switch disconnects power and releases the door.

Install sockets for medium (standard household) screw-in base light bulbs.

Hardwire these sockets to a power source.