These carriages and guide rails are steel.

Suitable for clean room use, these carriages and guide rails are made entirely of stainless steel.

Made of stainless steel, these carriages and guide rails are more corrosion resistant than steel carriages and guide rails.

Designed for use on horizontal surfaces, the contact angle of the ball bearings on the rail allows these carriages to last longer than other carriages.

These tiny carriages and guide rails are sized for electronic and other precision applications.

With a plastic cage that surrounds the ball bearings to prevent them from colliding, these extra-wide carriages run quietly for many cycles without needing maintenance. All of these carriages have a wide base and low-profile design to stabilize moment (twisting) and off-center loads better than other carriages.

A handle on the side of the carriage locks the carriage in place.

With a wide base, these sleeve bearing carriages stabilize moment (twisting) and off-center loads better than standard carriages. Use in areas where multiple carriages or rails won't fit.

Mate with a T-slotted rail to add linear motion to your assembly.

For applications with low clearance, these carriages protrude less than 5 mm above their rails.

Fasten loads on the side of these carriages and add linear motion to a T-slot assembly.

C-shaped guide rails grip the carriage around the outside to support linear motion along walls and other vertical surfaces.

These track roller carriages and guide rails are stainless steel for use in wet, corrosive environments.

Use these carriages and guide rails for light loads where precise movement is not required.

Needle-roller bearings give these track roller carriages higher load capacities than other track roller carriages.

Nylon rollers provide low-friction movement for light loads and corrosive environments.

Combine with a T-slotted rail to add linear motion to your assembly.

Made of stainless steel, these track rollers and guide rails are more corrosion resistant than steel rollers and rails.

With a row of crossed-roller bearings on each side of the rail, these slides have over twice the load capacity of standard low-friction slides and are better for handling shock loads.

Create your own positioning table or telescoping slide. Sets include four rails, two roller bearing cages, and eight end stops.

A linear scale and micrometer-like hand wheel measure travel distance in increments of 0.001".

A thumb screw locks the slide to prevent movement in systems where vibration is present.

Three micrometer handles ensure accurate, repeatable positioning along three axes—good for positioning parts, such as measuring and inspecting equipment, that are part of a larger automated system.

Two micrometer handles ensure accurate, repeatable positioning along two axes—good for positioning parts, such as measuring and inspecting equipment, that are part of a larger automated system.